0
you can purchase the mast, it comes with the nulon lead attached. remove the rubber seal from the top of the antenna and the retainer. turn on the radio and guide the mast from the antenna tube. check the legnth of the old nylon leader vs the new one. in the old one is shorter, some pieces are in the antenna housing. if so, then the antenna has to come out, sort of difficult with the muffler in the way. once out and unplugged take the side cover off and remove the pieces of the old leader, replace cover and reinstall the antenna. don't put the upper retainer on. plug in the antenna and guide the leader down the tube until you feel resistance. turn of the radio and let theleader pull in. align the mast and leader as it goes in the tube and let go all the way in. put the retainer on and then the seal and anything else that was removed. good luck
What else can I help you with?
How do you replace power antenna mast?
how do I replace a power antenna on my jeep Cherokee 1992
How do you change the antena for Infiniti G2 2002?
To change the antenna on an Infiniti G2 2002, locate the antenna base on the exterior of the vehicle. Unscrew the old antenna and disconnect it from the wiring. Attach the new antenna to the wiring and screw it into place on the antenna base.
How do you change the antenna mast for a 1988 Corvette?
I changed mine by going through the hatch as if you were going to change the tail lights. The other option is to remove the wheel and wheel well cover. More work and the car is up on a jack.
How do you repair the antenna mast on a 1992 Corvette?
Go to the Delco radio shop and ask for a rod and mast assemley. You then take the antenna apart and install the new parts. Hope this help out. cananda Remove the retaining nut, the wrench is in the mast kit. Have somone turn on the radio as you gently pull the antenna away from the car. If most of the white cable comes out with the mast, follow the diagram on the instruction sheet and orient the toothy part of the cable corectly. Have somone turn on the radio as you feed the cable in. Fasten the retaining nut and turn the radio on and off a few times.
How do you tarp a 03 ZO6 corvette over antennea?
if your antenna mast goes up and down when you tyun if on turn the radio off and it should go down if not remove the mast they just screw off the top if your antenna mast goes up and down when you tyun if on turn the radio off and it should go down if not remove the mast they just screw off the top
How do you install a power antenna mast or antenna on a four-door 1992 Acura Legend?
go to antennasRus.com buy the shaft and follow their easy instructions, I did it works great
Where can one purchase an antenna mast?
You can purchase an antenna mast at most auto shops like Auto Parts or Auto Zone. Many gas stations or garages will also carry the antenna mast for your car.
Where is the antenna mast assembly located?
remove inner fender passenger side antenna mast is right there back towards door you can get a new antenna for about 56 dollars
What causes the radio on a 1992 Chevrolet Corvette to cut in and out when the antenna works fine?
corrosion bad ground to test it buy a cheap antennea mast pep boys, auto zone for ten bucks plug it into radio put mast on dash if its good take out power ant. check wire if no good bad radio tuner good luck
How do you remove powered antenna mast from Mitsubishi Eclipse?
I removed the entire power antenna assembly and could not find any way possible to separate the mast from the motor assembly. Odd, since Mitsubishi sold me an antenna mast.
How to Change the antenna on a 1999 ford ranger?
if you are speaking of the mast (the actual part you see on the fender) it just unscrews
How do you install power antenna mast Lexus sc 430?
To install a power antenna mast on a Lexus SC 430, first, ensure the vehicle is turned off and the antenna is retracted. Remove the old mast by unscrewing it from the antenna housing, then disconnect any wiring if applicable. Next, insert the new mast into the antenna assembly, ensuring it clicks into place, and reattach any wiring. Finally, test the antenna to ensure it extends and retracts properly.
