How do you change the brake lights in a 2002 bravada?

Answer 1

In the trunk, you'll find two screws that, once loosened, will allow you to remove your light assembly. Take the bulbs out - I replace them all at once so not to have to do this again soon - and reassemble. Tom Pay It Forward

Answer 2

i am assuming that you are asking about the 3000gt brake lights. well here it is for 91-99 all models 3000gt`s replacing the brake lights is very easy with the back hatch open stand against the rear bumper of the vehicle and look down in the trunk area,on the interior plastic covers/trim there are 4 little bolts that you turn by hand(they are made of plastic)remove the square plastic covers from the trim and look inside(behind the trim)and you should see/feel two light build harnesses there is 2 per side on the 3000 gt twist them and pull the bulbs out they should be cheap and easily found in any parts store

This is not how mine work, I have to remove the covers in the turnk and then use a nut-driver (10mm) to remove 2 nuts and pull the housing assembly away from the car. then you have access to the lights.

Answer 3

1.Open trunk/liftgate.On sedan models remove the cover for access to the housing that contain the bulbs for the brake,tail,turn and backup lights. 2.On station wagon models remove the cover for access to the running lights.Remove three screws and rotate the housing away from the body for access to the brake,tail,turn and backup lights 3.To replace any rear bulbs,rotate the bulb holder 1/8 turn counterclockwise and pull it out of the housing,then push in on the bulb,turn it counterclockwise and remove it from the holder. High-Mounted Brake Light 1.Open trunk/liftgate 2.On sedan models the light is mounted on the rear package tray shelf,while on station wagon models the high mounted brake light is mounted to the underside of the liftgate glass at the top 3.Remove the screws and detach the cover from the brake light to access the bulb 4.Twist the bulb holder counterclockwise to remove it then pull the bulb straight out of the holder

Answer 4

This is what I found for the 2006 Chrysler SEBRING center brake light. Expert: Kevin

Date: 2/23/2008

Subject: 2006 Chrysler SEBRING center brake light

Question

How do you replace the center brake light inside the trunk lid?

Vehicle handbook gives details of the older type - housed under the parcel shelf Answer

REMOVAL

Disconnect and isolate the battery negative cable.

Remove fasteners from trunk latch cover by prying under the head of the fastener with a flat bladed tool.

Remove trunk latch cover.

Rotate socket counterclockwise one quarter turn.

Pull socket from back of lamp.

Pull bulb from socket. Link below: http://en.allexperts.com/q/Chrysler-Repair-807/2008/2/2006-Chrysler-SEBRING-center.htm

Answer 5

You can access the brake light assembly from the cargo compartment of your 1998 Dodge Neon. Remove the wiring harness from the back of the brake light. Remove the brake light retaining bolts. The brake light will come out. Reverse the process to install your new brake light.

Answer 6

There 2 screws when tailgate is open remove screws and pull out lens then unscrew toil light socket