you cross reference with 5 gallons of unleaded gasoline and a match
how to reset check engine light on 1992 Mazda mpv
To set the EVAP sensor on a Mazda MPV, first ensure that the vehicle's ignition is turned off. Then, connect a diagnostic scan tool to the OBD-II port and check for any trouble codes related to the EVAP system. Clear any existing codes and perform a system monitor or readiness test, following the tool's prompts. Finally, ensure the gas cap is properly sealed and check for leaks in the EVAP system before retesting.
check the rear brakes for wear. if ok then just ajust them up to proper specks
Look under the hood
"Why does my 1996 Mazda MPV EGI fuse keep blowing I previously had some lighting problems after launching a boat?"
The diagnostic code P2189 for a Mazda MPV indicates a "System Too Lean at Idle" condition, meaning that the engine's air-fuel mixture is too lean (not enough fuel) when the vehicle is idling. This can be caused by a variety of issues such as a vacuum leak, faulty fuel injectors, or a malfunctioning mass air flow sensor. Addressing this issue is crucial to ensure proper engine performance and prevent potential damage. Diagnostic testing and inspection are recommended to identify the specific cause.
Leaving the gas cap not tightly installed. Gotta be kept on and twisted fully into place. Most common reason this occurs.
Maybe misfiring on cylinder 6. Or 4. Take the car to autozone, they scan codes for free!
The engine is overheating.
Check for a blown fuse.
Have vehicle scanned to determine the problem
how do I repair error code p2009. show image of part involved