check the rear brakes for wear. if ok then just ajust them up to proper specks
You have to follow the cable from steering column to tranny, there is a plastic push thing to adjust the endplay, make sure it is not broken or worn out, better to just buy new cable and adjust it during the install
was wondering where the inertia switch is on a 1996 Mazda protege
Mazda Demio was created in 1996.
To replace the power steering belt on a 1996 Mazda Lantis, first, disconnect the negative battery terminal for safety. Loosen the tensioner bolt and the adjustment bolt on the power steering pump to relieve tension on the belt. Remove the old belt and install the new one, ensuring it fits properly on the pulleys. Finally, re-tension the belt, tighten the bolts, and reconnect the battery.
open hood. On top of each headlight there is an adjustment screw. Turn it either way to lower/raise the headlight
This is from the Owners Handbook of my Mazda 323, 1996 : Alternator Drive Belt. 1. Loosen the alternator mounting bolt and adjusting bar bolt. Replace Fanbelt. 2. Turn the adjusting bolt until the correct tension is obtained. The deflexion should be 10mm. 3. Tighten bolts and recheck the tension.
Where exactly it the fuel filter located on my 1996 Mazda protege 1.5 motor.
what size speaker fits Mazda 626 1996 model front door
The spark plug gap for a 1996 Mazda Familia should be set between 1.0 and 1.1 mm. This is stated in the adjustment data from Mazda.
with a key.
dominican republic
You can find an exploded view of the 1996 Mazda Millenia 2.5 liter engine at most Mazda dealerships. You can also find the exploded view in most Mazda service manuals.