0
What else can I help you with?
How can I find a short in a wire?
To find a short in a wire, you can use a multimeter to test for continuity along the wire. Set the multimeter to the continuity setting and touch the probes to each end of the wire. If the multimeter beeps or shows a reading of zero ohms, there is a short in the wire.
Is electric resistance greater in a short wire or a long thin wire?
Resistance is the restriction of electrical flow in a component/wire/etc. If you think of a short fat wire as a short freeway and a long thin wire as a quiet country road then the answer is easy to find especially if you imagine 1 thousand cars all trying to travel the distance at once
The fuse for my stereo in my 1993 olds 88 keeps blowing what is a short how do you find the short and what does a short look like?
a short is a cut in a wire and it will probally be behind the fuse panel if its for your radio.
My Power window on the drivers side of 2000 Pontiac sunfire won't work?
This could be caused by a blown fuse or a short in the wire. If its a blown fuse, replace it. If it is a short you get to play follow the wire from the window control button until you find the short.
Why does your 1996 jeep grand Cherokee Main fuse keeps blowing when you turn the key on?
The fact that it is a grand Cherokee has nothing to do with it. The fact that you have an electrical short has everything to do with it. Open the hood. Find the battery. Find the red wire from the battery. Trace the red wire and the wires leading off from it until you find the spot where you can see the insulation removed and there is bare wire. Replace that wire. Hopefully that caught it. If that did not catch it, then it will be necessary to get a volt meter and find the specific wire that has the short. If it is not is a bare wire, it may be in a broken piece of equipment. You need to find out where. Since you want to learn about your vehicle without working with another back yard mechanic like the rest of us did, that is a possible way. You have to find the short and replace the bad part.
How deep should electrical wire be buried to ensure safety and compliance with regulations?
Electrical wire should be buried at a depth of at least 18 inches to ensure safety and compliance with regulations.
How can you know accurately the location of a the broken section of an electrical wire is?
how can I know accurately the location of a the broken section of an electrical wire is?For example if I have a wire of 10 meters long buried underground and somewhere along these 10 meters the wire is broken(short circuited), can I using only one end of the wire know where exactly that short circuit is located along those 10 meters ????There is a way to do that but I need just the principle of how does it works anybody can help please.___________________________X______________.6m 4m The best way, and safest, remove the wire and replace it. no i am not concerned about taking it out an replacing it, for example if the wire is 30km long and buried 3 meters underground, it will be very very hard job to do by taking it out but if i can know where exactly the fault is i will have to dig only at that place
What are the release dates for Short Short Dramas - 1952 Buried Treasure 1-34?
Short Short Dramas - 1952 Buried Treasure 1-34 was released on: USA: 22 January 1953
What is burial wire?
It is a wire with special insulation that protects it under ground. On the wire there will be a stamp "UF" or underground feeder. That means that it can be buried directly in the earth.
A lightning rod is connected to a heavy wire buried in the soil to?
yes
What is direct burial wire?
It is a wire with special insulation that protects it under ground. On the wire there will be a stamp "UF" or underground feeder. That means that it can be buried directly in the earth.
98 dodge neon ac blower fuse blows?
Shorted wire! Either re-wire it or find the short and repair. I'm about to fix this same problem on my neon!
