To fix a license plate light on a 1995 Dodge Colt you must first remove the screws holding the light cover in place. Remove the light from the bumper completely. Remove the license plate light bulb from its socket and replace with a new bulb. Place the light assembly back in its place in the bumper. Secure the light assembly in place with the screws you removed.
yes it does
Open trunk, plate fits through a slot--just push up from the outside front of plate
Remove the center false reflector by inserting a small screwdriver between the fog light and reflector to release the tab. Remove the 2 screws on the fog light. Insert the small screwdriver in the other side(closest to license plate) of the fog light to release the tab and pull firmly outward from this side(closest to license plate).
You have to pop out the harness that holds it on to your bumper. Youll be left with a wire with the light on the end of it. Take it apart, and there is your light bulb.
Yes my husband had to drill a hole in his trunk behind the license plate and got in the trunk
To replace the license plate lights in a 1995 Toyota 4Runner, first, locate the light fixture above the license plate. Use a flathead screwdriver to gently pry off the plastic cover of the light assembly. Remove the old bulb by twisting it counterclockwise and replace it with a new bulb, then reassemble the fixture by snapping the cover back in place. Finally, test the new lights to ensure they are functioning properly.
look for a blown in line fuse, 3 prong red box by back lights.
i have a 95 Prizm and i just bolted the plate to the bumper. it does the same the as a bracket. but it cost no money.
The light is on when there is a failure in the safety restraint system.
unbolt lens, remove bulb socket quarter turn
The alternator/generator is not charging.
Push the button.