0
What else can I help you with?
How to Fix a leaning quick set pool?
only way to fix it is relevel it drain it all out and level the ground correctly
What type of concrete is used to fix a concrete inground pool?
I have etching in my inground concrette pool and i need to know how to fix it. the pool was made in 1973 i bought the house three years ago.
How do you fix a pool waterfall?
Call a plumber
How do you get DE powder out of the pool water?
Firstly you find out how the DE got into the pool - must be a broken filter pad. Fix that, then vacuum the pool. No point vacuuming before you fix the filter problem, or the DE will finsih up back in the pool.
How can I fix pool liner from pulling away from return hole?
To fix a pool liner that is pulling away from the return hole, first, drain the pool to a level below the return fitting. Carefully reattach the liner by smoothing it out and ensuring it is properly seated around the return hole. You can use a pool liner adhesive or tape for added security, and then refill the pool, ensuring the liner is evenly distributed as the water rises. Finally, check for any leaks around the return fitting and adjust as necessary.
I live in Memphis Tn and I would like to know if you think my pool has a leak or is this normal evaporation My pool is 10 x 32 by 4 feet deep is this normal or do I have a leak?
A good way to see if you have a leak in your pool is to # take a bucket and fill it with water from your pool. # mark it at the water level. # mark the pool at the water level. # wait a few days if there is no leak in the pool then the water level in the bucket should have reduced by the same amount as the water level in the pool, however if the water level in the pool has gone down more then the water level in the bucket you have a leak in the pool or in the pipes around the pool.
How do you fix unlevel 16x32 pool?
To fix an unlevel 16x32 pool, start by draining the water to prevent further damage. Next, identify the low spots around the pool's perimeter and excavate the soil underneath to create a level base. Use sand or gravel to fill any low areas, compacting it firmly to ensure stability. Finally, refill the pool and check for levelness, making any necessary adjustments before adding water back in.
My above ground pool is uneven fix it with out draining it.?
I have a 15' above ground pool, when we installed the pool it was a little uneven (not even 1") now that the pool has been up for a while it has settled and now the side that was lower is off by about 3-4". How can I fix this without draining the whole pool?
What is the purpose of balancing tank in reflection pool?
If you have a deck level pool or spa (water level with the top of the pool, that usually overflows into a grating around the pool) when people get into the pool their body displaces water, this water is stored in the Balance tank until the people get out and the water is pumped out of the balance tank and back into the pool. A skimmer pool that has a lower water level than the top of the pool does not need a balance tank as the displacement is handled by the water level rising. Deck level pools and spas are considered more aesthetically pleasing.
How do you fix caretaker for pop ups on pool?
To fix a caretaker for pop-ups on a pool, first ensure the caretaker's mechanism is clean and free of debris. Check the water level to ensure it’s adequate for proper operation. Inspect the hoses for any leaks or blockages, and ensure the caretaker is properly connected to the pool's filtration system. If problems persist, consult the manufacturer’s manual for troubleshooting tips or consider professional maintenance.
How can I detect a leak in a pool?
To detect a leak in a pool, you can perform a simple bucket test. Fill a bucket with pool water and place it on the pool steps. Mark the water level inside the bucket and the pool water level. After 24 hours, check if the water levels have changed. If the pool water level has dropped more than the bucket water level, it may indicate a leak.
How can I detect a leak in my pool?
To detect a leak in your pool, you can perform a simple bucket test. Fill a bucket with pool water and place it on the pool steps. Mark the water level inside the bucket and the pool water level. After 24 hours, compare the two levels. If the pool water level has dropped more than the bucket water level, it may indicate a leak.
