On a 1998 Harley-Davidson Heritage Softail, the neutral switch is located on the transmission. Specifically, it is typically found on the left side of the transmission case, near the shift lever area. This switch helps to indicate when the motorcycle is in neutral and is crucial for starting the engine safely. If you need to access it, you may need to remove the outer primary cover for better visibility.
Some vehicles have the Accessory position in the opposite direction from the Run/Start position.
The acc switch in an automobile is an accessory switch. It is used for listening to the radio or other electronic equipment in the car with the engine turned off.
Did you mean "Nokia 3120 classic"?
Yes, the ignition switch must be in the ignition position -not- the accessory position.
The started putting computers in the bikes a while back. The engine light stays on for a few seconds after turning the ignition switch on to allow the fuel pump to pressureize and the computer to boot up and callibrate. You should NOT start the bike before the light goes out!
No.
yes that is it
insert key into ignition and turn to accessory and get a pin and depress it into the hole by the key and pull the switch out and then you can unscrew the big nut off the switch.
the front switch is inside the handlebar right controll, the side the lever is on. you have to take this apart to se it, 2 torx screws, the back switch is located i n the brake line on the line to the rear caliper.
Most likely cause is a problem with the front brake light switch located in the right switch housing on the handlebars. If you installed new levers you may have ones for a different model or the clip that holds the switch my have fallen out.
You turn on power to the accesories, ie radio, power outlet, etc.