1. Close all doors.
2. Turn the ignition key to position II.
3. Simultaneously press the accelerator pedal and the brake pedal and hold for a minimum of 15 seconds.
4. The oil change reminder indicator will turn off. This confirms that the reset procedure has been correctly completed.
put ur car on ignition without starting engine and press down acclater and brake padel for at least 20 seconds and problem will be solved thanks
56 l
To reset the service light in a 2008 Seat Alhambra diesel, turn the ignition key to the "on" position without starting the engine. Press the gas pedal three times within 10 seconds. Then, turn the ignition off and back on to check if the service light has been reset. If it remains on, repeat the process.
How do you reset 2008 honda element service light?
To bleed a 2008 Ford Mondeo diesel engine, first, ensure the fuel tank has enough diesel. Locate the fuel filter, and if it has a bleed screw, loosen it slightly. Then, turn the ignition to the "on" position without starting the engine; this will activate the fuel pump and help purge air from the system. Once fuel flows steadily from the bleed screw, tighten it, and start the engine. If necessary, repeat the process until the engine runs smoothly.
why is my service 4 wheel drive light on on my 2008silverado
take a hammer to the light
For a 2008 Ford Mondeo TDCi, it's recommended to use a fully synthetic engine oil with a viscosity rating of 5W-30, compliant with the Ford WSS-M2C913-C or WSS-M2C913-D specifications. This type of oil provides optimal protection and performance for the diesel engine, especially in varying temperatures. Always check your owner's manual for specific recommendations and oil change intervals.
Break It Down - 2008 Diesel Locomotive was released on: USA: 2008
Resetting a service engine light on a 2008 Volkswagen r32 requires a diagnostic tool to be done properly. Another way requires disconnecting the battery for 5 seconds or more.
Resetting an 2008 Audi A3 TDI service light can be done two ways. One by addressing the problem and the other way is to unhook the battery cables for up to a minute.
There are a couple of ways to reset the timing belt light on a 2008 Toyota Hilux diesel. One way is to unplug the battery for up to five minutes and see if that will reset the light. If not, you can hold the trip meter button down and turn the key, but not start the vehicle. This will reset the light most of the time.