answersLogoWhite

0

To read a check engine code a person will need a code reader. They can also take their vehicle to an Auto Zone store and have them read the codes and explain what they mean for free.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

What could make me lose speed in 5th gear in a 1990 jeep 4.2?

Check for codes if you have a check engine light illuminating.


Why would a 1990 olds ninety eight run rich when cold start Service engine and temp light on No codes?

If the check engine light is on with no codes, you have a wiring or computer issue.


How do you check the mil codes on 1990 gmc suburban?

To check the MIL (Malfunction Indicator Lamp) codes on a 1990 GMC Suburban, you can use an OBD-I scanner or a paperclip for a manual method. Locate the diagnostic connector under the dash near the driver's side. Use a paperclip to short terminals A and B on the connector, then turn the ignition to the "On" position without starting the engine. The check engine light will flash a series of codes that indicate any trouble codes stored in the vehicle's computer.


How do you retrieve computer codes from a 1990 Plymouth Grand Voyager?

turn the key on and off 3 times and count the check engine flashes


What does 1990 dodge spirit check engine code 55 mean?

55 Means End of Code... Its nothing to worry about. Just means there is no codes


Where is the connection to reset a check engine light on a 1990 Nissan pickup truck?

There is no OBD connection on a 1990 Nissan as that is an OBD1 vehicle not OBD2. However there is a way to read the codes. https://codes.rennacs.com/Petrol-Engine/Japanese-Korean/Nissan-Engines.php


How do you check engine codes on a 1990 lemans le with a 16 engine?

on top of the computer you should find a wiring harnes one of them dose not have a end. and that is war you plug it in. on the right kick panel.


Engine codes Honda?

what is code 14 in Honda civic 1990


How do you read diagnostic codes on 1990 300zx?

To read diagnostic codes on a 1990 Nissan 300ZX, first, locate the diagnostic connector under the driver's side dashboard. Use a jumper wire to connect terminals E1 and TE1 in the connector. Then, turn the ignition key to the "on" position without starting the engine; the check engine light will blink the diagnostic codes. Count the blinks to interpret the codes according to the Nissan service manual for troubleshooting.


Why does my 1990 Chevrolet Silverado run for 30 minutes and the check engine light comes on when its warm It idles rough and dies on highway with a random check engine light?

Have vehicle scanned to determine problem and recover codes Could be a bad coolant temperature sensor


1990 dodge caravan 3.3l not getting fire to the ignition coil?

It could be the coil pack or the crankshaft position sensor. run the codes by turning the key on, off, on, off, on without turn the key to start position. shotly after the check engine light goes off, the check engine lght will flash 2 digit fault codes. if 11 is one of the codes its likely a bad crank sensor.


How do you retrieve the check engine light on a 1990 cavalier?

The check engine light cannot be retrieved on a 1990 Cavalier unless a problem develops with the engine. The engine can be checked for errors, though, by using a tester that is plugged into the vehicle's computer.