answersLogoWhite

0

The seats on a 1992 Acura Vigor use bracket which are found underneath and behind them. Loosen the bracket bolts to release the seats Pull them off and replace them.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you replace a timing belt on a 1992 Acura Vigor 2.5L?

HOW TO REPLACE A TIMING BELT ON A 1992 ACURA VIGOR? how do you change a timing belt on a 1992 acura vigor 2.5l how do you change a timing belt on a 1992 acura vigor 2.5l -------------------------------- See article at the Acura Vigor Club -- Related Links (below).


Where is the fuel pump on a 1992 Acura Vigor?

Where is the fuel pump locate on the 1992 acura vigor


How do you remove factory stereo on a 1992 Acura Vigor?

view website www.cdplayerrepair.com/remtips/vigor_rem.htm


Will a 1992 vigor Acura rim fit an 2002 Acura RL?

i dont kniw


Cant find the location of the drain plug for a 1992 Acura Vigor?

The drain plug for a 1992 Acura Vigor is typically located on the oil pan at the bottom of the engine. You can find it towards the rear of the oil pan, usually on the driver's side. It's a hex-shaped bolt that may require a wrench or socket to remove. Make sure to use a drain pan to catch the old oil when you unscrew it.


Speaker size 1992 Acura Vigor?

1992-94Vigor6 1/2"6x9"


How do you adjust the idle on a 1992 Acura Vigor?

On a 1992 Acura Vigor idle is adjusted through a idle control valve. Tightening the valve well raise the lower the idle and loosening it will raise it.


Where is the drain plug on a 1992 Acura Vigor?

The drain plug on a 1992 Acura Vigor is located on the oil pan, which is situated at the bottom of the engine. To access it, you will need to lift the vehicle and look for a bolt or plug at the lowest point of the oil pan. It's typically a hex or square shape, and you'll need the appropriate tool to remove it for oil changes. Always ensure to have a drain pan ready to catch the old oil.


How do you remove the starter on a 92 acura vigor?

To remove the starter on a 1992 Acura Vigor, first disconnect the negative battery terminal to ensure safety. Then, locate the starter, which is typically situated on the engine block near the transmission. Remove the electrical connections and the mounting bolts securing the starter in place. After detaching the starter, you can carefully pull it out from its housing.


What does the main relay mitsuba rz-0109 control on a 1992 Acura Vigor?

Fuel


What is the correct placement of distributor wires from the spark plug to the distributor cap on a 1992 Acura Vigor?

123c54


If your fan is not working in your 1992 Acura Vigor what could it be other then the temperature censor?

Relay or fan itself