Try going to a hardware store & buying a coping saw blade {it looks like a piece of wire with a spiral cut running down it} cut the end off the blade and with the ignition turned to the place where you would pull the key out, slide the wire of the blade in next to the key and gently slide it out.... the spiral cut in the blade should grab the key and pull it along with the blade.... if that doesn't work you may need to see a locksmith.
i have a 06 Chevy cobalt and can't get the key out of the ignition switch
how to remove key stuck in ignition switch in Chevy colbalt
See You-Tube Video : http://youtu.be/lBNUuO4ldfI How to Remove a broken key from an Ignition. Using the Broken Key Extractor Kit from: www.WedgeCo.com
The entire ignition switch assembly will unholy from the steering column. The key is required to remove the cylinder from the switch.
To remove the ignition lock cover with a broken key stuck in the ignition, first ensure the vehicle is off and disconnect the battery for safety. Use a small screwdriver or a pick to try and extract the broken key piece from the ignition. If that doesn't work, you may need to remove the steering column cover by unscrewing it, which typically involves removing screws located underneath the steering wheel. Once the cover is off, you can access the ignition switch to replace it or remove the lock cylinder if necessary.
Yes, a broken key can prevent a 1999 Buick LeSabre from cranking if the broken part is lodged in the ignition or if it disrupts the connection needed to turn the ignition cylinder. Additionally, if the key is broken in a way that prevents proper engagement with the ignition switch, the vehicle won't start. It's advisable to remove the broken key piece and use a spare key, or consult a locksmith for assistance.
Chevy Tahoe Ignition Key Starter Switch
NOOO get the broken key out of the ignition by pulling the black protector off and then take your key to a key maker and have him replicate the toothing from your key
To remove the ignition switch key lock on a 1989 Jeep Wagoneer, first disconnect the battery to ensure safety. Then, remove the steering column cover to access the ignition switch. Locate the retaining screw or pin on the ignition lock cylinder, turn the key to the "run" position, and press the pin or screw to release the lock cylinder. Finally, pull the key lock out of the ignition switch.
With no key you will have to drill out the existing tumbler assembly from the switch in order to unscrew the ignition switch bezel.
Take it out haha
If you can reach the broken key with a pair of needle nose pliers, you may be able to pull it out. Otherwise, it is a job for a professional locksmith.