To remove the ignition lock cover with a broken key stuck in the ignition, first ensure the vehicle is off and disconnect the battery for safety. Use a small screwdriver or a pick to try and extract the broken key piece from the ignition. If that doesn't work, you may need to remove the steering column cover by unscrewing it, which typically involves removing screws located underneath the steering wheel. Once the cover is off, you can access the ignition switch to replace it or remove the lock cylinder if necessary.
See You-Tube Video : http://youtu.be/lBNUuO4ldfI How to Remove a broken key from an Ignition. Using the Broken Key Extractor Kit from: www.WedgeCo.com
how to remove key stuck in ignition switch in Chevy colbalt
If your key is stuck: on the underside of the steering column cover there is a round recess cover. Remove the cover and using a pecil push up through the recess.
remove battery cable
There should be a lock on the ignition a push button that you push and turn to remove the key
To remove a key that is stuck in the ignition on a Peugeot 406 HDI, make sure that the car is in park. Then try to remove the key. If this does not work, spray the ignition mechanism with WD-40 after pulling out the key as far as possible. Then work the key in and out until it comes out.
Well, it sounds like the chip that is in your key may have broke or got stuck on a part of the ignition. I had that problem. This happened not long after I had had to have the ignition replaced?!?
Use the opportunity to replace the ignition. Key needs to be in On position for removal.
You can't, you have to replace the ignition switch
Try to put your car on the parking breakes.
you will have to drop the fuel tank and remove the pump gauge unit. it maybe stuck, broken wire, or simply bad.
WELL THE BEST THING TO DO WHILE THE KEY IS IN THE IGNITION IS TO REMOVE THE CYCLINDER IF ITS LIKE MOST VEHICLE THERE IS A PIN HOLE KEY CYCLINDER WITH A PAPER CLIP INSERT IT IN THE PIN HOLE TURN THE KEY AND REMOVE THE CYCLINDER IN SOME VEHICLE YOU HAVE TO REMOVE THE STEERING COLUMN COVER AND PUSH THE PIN IN AND REMOVE THE CYCLINDER WHICH EVERWAY YOU HAVE TO REMOVER THE CYCLINDER GOOD LUCK