Probably same as the XJ8. Turn the wheel 90 degrees from center. There are little access holes on both sides of the back of the wheel in the plastic cover. Recessed in the holes are TORX fasteners, I think #35. There is one on both the left and right sides of the back of the wheel. DISCONNECT THE BATTERY FIRST AND WAIT 30 MINUTES BEFORE DOING THIS! Disconnect the airbag and radio/cruise switches. Remove the left and right horn push bars. Unscrew the steering wheel nut (15mm) Remove wheel. Slide off the radio and cruise swtiches. Mount all this on the new wheel, plug it all back in, screw the nut back on and you're done. Make sure you have the wheel centered before removal.
4 bolts are romoved from the backsode of the steering wheel. If airbag equipped remove airbag fuse first. Then remove airbag/ horn/ center assembly. Remove large nut from center of wheel, then pull wheel with steering wheel puller.
To remove the steering wheel start by disconnecting the negative battery terminal to prevent accidental airbag deployment. Then remove the screws on the backside of the steering wheel to remove the airbag. Disconnect the airbag wiring connectors. Remove the steering column shaft nut and remove the steering wheel with a puller. Do not yank, hammer, pry the steering wheel off as this could result in steering shaft damage.
To remove the steering wheel from a 2007 Suzuki XL7, first, disconnect the negative battery cable to prevent airbag deployment. Then, carefully remove the airbag by unscrewing the retaining screws located on the back of the steering wheel. Once the airbag is detached, disconnect the airbag connectors and set the airbag safely aside. Finally, use a steering wheel puller to remove the steering wheel from the steering column by unscrewing the central nut that holds it in place.
To remove the steering wheel on a 1996 Camaro, first disconnect the negative battery cable to prevent airbag deployment. Then, carefully pry off the airbag cover and remove the airbag connector. Next, use a steering wheel puller to remove the steering wheel bolt, and finally, pull the wheel off the steering column. Be sure to follow safety precautions, especially regarding the airbag system.
simply pull tha airbag fuse. remove the 4 torx head scres behind the airbag and remove airbag. unplug theelectrical connector. remove the big nut holding the steering whell. use a puller to remove the steering wheel.
To remove the steering wheel on a 2002 Land Rover Discovery, first disconnect the battery to avoid accidental airbag deployment. Then, remove the airbag by unscrewing the retaining screws on the back of the steering wheel. After the airbag is removed, disconnect the airbag connector and use a socket wrench to remove the central nut holding the steering wheel in place. Finally, pull the steering wheel off the shaft, being cautious of any alignment markers.
ok you have to check on your steering wheel in back of you steering wheel there will be a 2 or 4 bolts you gonna have to remove ,as soon your remove you steering wheel airbag you should see 2 wires one goes to airbag on other will be connected to you steering wheel switches ,,you should remove that and after that you gonna see one bolt you should remove it and you can after that you should be able to pull you steering wheel
To remove the steering wheel on a 2001 Trans Am, first disconnect the battery to avoid any electrical issues. Next, remove the airbag by unscrewing the retaining bolts on the back of the steering wheel and carefully disconnecting the airbag connector. Once the airbag is removed, use a steering wheel puller to loosen the steering wheel by removing the center nut and pulling the wheel off the steering column. Make sure to note the alignment for reinstallation.
To remove the steering wheel from a 2004 Mercury Monterey, first disconnect the negative battery cable to ensure safety. Next, remove the airbag by unscrewing the retaining screws on the back of the steering wheel, then carefully detach the airbag connector. Once the airbag is removed, use a steering wheel puller tool to remove the steering wheel by unscrewing the central nut and applying pressure with the puller. Finally, gently pull the steering wheel off the column.
you would need to disconnect the airbag then pop off the horn pad and remove the airbag then unbolt the steering wheel.
To remove the steering wheel on an Oldsmobile Aurora, first disconnect the battery to ensure safety. Then, use a small tool to release the airbag by removing the screws or clips on the back of the steering wheel. Once the airbag is safely detached, disconnect the wiring harness and remove the center nut holding the steering wheel in place. Finally, use a steering wheel puller to gently remove the wheel from the column.
To remove the steering wheel from a Citroën C1, first disconnect the battery to ensure safety. Next, remove the airbag by unscrewing the bolts on the back of the steering wheel, then carefully disconnect the airbag connector. Once the airbag is removed, use a steering wheel puller to unscrew the central nut and pull the steering wheel off the column. Be cautious of the clock spring and ensure all connectors are properly handled during the process.