There are two screws that hold the fog light in place. You have to go underneath the bumper to get to it. Your best tool will be a small ratchet type wrench. The foglamp is a one piece unit. Just unplug it from the harness and take out the two screws.
Remove the headlight assembly to gain access to the bulbs.
Remove the headlight assembly to gain access to the bulbs.
How do your remove the lamp housing from a 2002 silverado driving lights? I can remove the upper head light housing but I can't get the driving light housing out.
To change the headlight assembly on a 2002 Chevy Silverado, first, open the hood and disconnect the negative battery cable for safety. Remove the screws or clips securing the headlight assembly, typically found on the top and side of the assembly. Carefully pull the assembly out and disconnect the wiring harness. Install the new assembly by reversing the steps, ensuring the wiring is securely connected and the assembly is properly aligned.
you have to remove the turn signal light and some of the trim (grill) to get to the screws that hold the light assembly in place. 10 minute job.
remove front headlight assembly to get at horn,it is down below light assembly..
Remove the two securing lock pins and pull out
To remove the tail light lens on a 2002 Lexus LS430, first, open the trunk and locate the access panel behind the tail light assembly. Remove any screws or clips securing the access panel, then gently pull it away. Disconnect the electrical connector from the tail light assembly, and remove the screws holding the tail light in place. Finally, carefully pull the tail light assembly out, and the lens can be detached from it.
how do you replace ambient light sensor on 2002 silverado
Open hood and at the headlght assembly you'll see two (2) pins which hold the headlight in place pull pins up and out and you can remove the headlight assembly. On the running light assembly there is a clip towards the grill side which will release that assembly. Then simply twist out the old assembly and install new lamp. Try not to touch lamp as the oils from your fingers will shorten the bulb life.
To replace the brake light on a 2002 Lexus LX470, first, open the rear hatch and locate the tail light assembly. Remove the screws or bolts securing the tail light, then gently pull the assembly out. Disconnect the wiring harness and remove the old bulb by twisting it counterclockwise. Insert the new bulb, reconnect the wiring harness, and reattach the tail light assembly with screws or bolts.
Open the hood. Remove the black plastic cover that goes across the top of the headlights/radiator. Remove the two silver screws that are on the top of the headlight assembly. Then remove the light housing...Not much holding them on.