remove the left mud flap and using a strap wrench turn the filter counterclock wise, if strap wrench slips to much ,drive a screwdriver through the darn thing and try to turn it that way.
Classic and Nomad, Yes. Drifter, No.
How do you remove seat off Kawasaki nomad
Hi, I'm not sure how old this is but I needed the same info and found it here. http://www.motospeed.se/files/pdf/I201-411.pdf regards Dave
3.5 with new oil filter
I was told by the previous owner of my 1999 1500 Kawasaki Drifter that there were only 500 produced in 1999. He had the production number engraved on the handlebar tree, along with the name he gave the bike.
To change the clutch fluid in a Kawasaki 1500 Drifter, first locate the clutch reservoir and remove its cover. Using a clean syringe or turkey baster, extract the old fluid from the reservoir. Then, refill it with new hydraulic fluid, typically DOT 4 or the manufacturer-recommended type. Finally, bleed the clutch system by loosening the bleeder valve at the clutch actuator while pumping the lever until no air bubbles appear, then tighten the valve and check the fluid level again.
1998 Kawasaki Vulcan Classic 1500
remove the transmission pan. then remove the filter.
what engine will interchange with a 1997 kawasaki vulcan 1500
Were is located the starter in a kawasaki 1500cc year 97
Drain the fuel from the fuel tank. Remove the fuel line from the fuel filter. Remove the fuel filter plate. Remove the fuel filter retaining bolts. Reverse the process to install the new fuel filter.
The 1500 Kawasaki Vulcan typically requires about 3.5 quarts of oil when performing an oil change with a new oil filter. If you're just changing the oil without replacing the filter, it usually takes around 3 quarts. Always check the owner’s manual for the most accurate specifications and recommendations for your specific model.