you squeeze the tabs in the middle gently inwards then pull the cover toward the front of the car.the brake light housing itself has a tab on either side of it that you need to press to remove the light .
i believe that the antenna for these cars are on the rear window - the two vertical lines that are near the window brake light.
In the top of the trunk near where the brake light is located, there is a small plastic window, remove it and you access the light bulb.
How do i change the 3rd brake light on a mercedes vito van.It is the brake light above the back door?
To replace the third brake light on a 2004 Mercedes E-Class, first, open the trunk and remove the trim panel covering the brake light assembly. Disconnect the electrical connector and remove the screws securing the brake light. Replace the old light with the new one, reattach the screws, and reconnect the electrical connector before replacing the trim panel. Test the light to ensure it functions properly.
Remove your 1998 Honda rear window brake light cover. Push the light bald in and turn at the same time. The light bulb will come out. Reverse the process to install the new light bulb.
To remove the third brake light from a 1987 Mercedes Benz 560SL, first, open the trunk and locate the light assembly. Carefully pry off any plastic covers or trim pieces that conceal the screws or fasteners. Unscrew the mounting screws and disconnect the wiring harness from the light. Once disconnected, you can remove the light assembly from its position.
if the high mounted brake light is in rear window. open trunk and access the light from below rear window shelf. if the light is in the spoiler, remove the screws holding it in. disconnect elec, connector from inside of trunk lid. the assembly has no replaceable bulbs, and has to be replaced as a unit..
more information needed is it in the window or the design in the spoiler
To replace the brake light bulb on a 2002 Mercedes CLK320, first, open the trunk and locate the taillight assembly. Remove the screws or clips securing the taillight, then gently pull the assembly out. Turn the bulb socket counterclockwise to remove it, replace the old bulb with a new one, and reassemble by reversing the steps. Ensure everything is securely fastened before testing the new brake light.
Get in the back seat and grab the rear brake lite and pull the cover toward you. Bulbs are then remove able.
remove the sensors and clean it. then put it back. if the warning light is still replace the sensors it is cheap
Where is right brake light fuse on a 1999 Mercedes E320? Thank you.