How to replace the rear window motor on a 2001 Sport Trac: 1. fold down the rear seats. 2. flip up and remove the spring-loaded hinge on the cargo platform by removing the philips-headed screws. 3. remove the plastic fasteners for the rear plastic body panel. 4. pry the plastic rear body panel from the tabs at the top (left and right). 5. remove the two plastic felt fasteners. 6. peel down the motor cover located behind the rear right seat. 7. remove the 3 torx bolts on the motor. 8. using a large screwdriver or small pry bar, pry the motor away from the cable spool, leaving the spool intact on its mount. 9. unplug the motor and remove. 10. using a screwdriver, rotate the spool to give it some play (the window should move some). 11. put a dab of grease on the motor hub. 12. install the new motor by aligning the hub splines and rotating the motor into position. tighten the torx bolts. 13. Reassemble everything. 14. Initialize the new motor: open door, turn key to 'on', push rear window button 6 times, turn key to 'off', push rear window button 6 times, turn button right until window closes all the way, turn button left until window opens all the way.
Yes
How do I replace the rear wiper motor or just remove the rear panel on the back window to see if my rear wiper motor is unplugged on my 2007 Subaru Outback? Thanks!
The rear window motor on a Honda Odyssey is replaced by removing the cover screws, disconnecting the wiring harness, and unbolting the motor. A new motor can then be put in place and bolted in.
you have to remove the 2 brackets of the rear panel situated where the rear window close, then take the rear panel up, that's all
remove rear seat panel
replace rear window wiper motor on 2001 Chevy venture
To replace the rear window drum housing in a 2001 Ford Explorer Sport Trac, first, remove the interior panel from the rear door to access the window components. Then, disconnect the window motor and any linkage connected to the drum housing. Remove the screws or bolts securing the drum housing and carefully take it out. Install the new drum housing by reversing the removal steps, ensuring everything is reconnected securely before replacing the interior panel.
Check if there is voltage to window regulator motor; if there is replace motor.
Just use a flat head screw driver to pry it off.
replace window regulator and/or motor
if the motor is turning then it could be off the track or a gear might be stripped.
To replace the rear window motor in a 2003 Toyota Sequoia, start by removing the interior panel of the rear door using a trim tool to carefully pry it off. Disconnect the electrical connector from the old motor, then unbolt the motor from the door frame. Install the new motor by reversing the steps: bolt it in place, reconnect the electrical connector, and reattach the interior panel. Finally, test the motor to ensure it operates correctly.