S-10, 1995-2004 4WD Hub Bearings. Remove axel center cap Loosen axel nut with breaker bar (and pipe if needed) Raise truck and support remove lugs and tire Remove brake caliper slide bolts 15 mm Remove caliper mounting bolts 18mm Remove rotor Remove 3 hub mounting bolts from behind spindle (use a small jack on lower control arm to gain clearance to top bolt) Use a puller to separate old hub assembly from steering knuckle leave or remove brake sheild clean/spray spindle and wipe clean all areas use anti-seize on the 18mm hub bolts(because you'll be doing this job again in a year or 2) lower truck and start saving for the next set of bearings.. longovette@windstream.net
You will need to remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new will bearing.
Here is a link to some good instructions. http://reviews.ebay.com/ebaymotors/Chevy-Silverado-4x4-Front-Wheel-Hub-Bearing-Replacement_W0QQugidZ10000000002536494
how to replace front wheel bearing on 1996 Hyundai elentra
It's a sealed unit with the hub. You have to replace the whole hub assembly.
To replace the front wheel bearing on a Ford Fiesta, you will need to remove the wheel. Then with a hammer you can pull the old bearing out.
The front wheel bearing assembly is not repairable. A new wheel bearing assembly is replaced as a complete unit. Your local auto parts store can supply you with a new bearing assembly.
Take wheel off, put bearing in
36mm
Is the wheel bearing on the front or the rear ????.. There is a big difference ...
You can replace the front wheel bearing, on your Kawasaki Mule 3010, by removing the axle. With the axle Remove the wheel bearing will slide off.
The front wheel bearing is a sealed unit with the wheel hub - replace the hub and wheel bearing unit. Remove the four bolts from the rear of the steering knuckle that connect to the hub bearing unit.
you can replace it by taking it to the shop and they will do it for you.