you will have to order it from a dealer, when you receive which is should be next day remove defrost vent, there will be a screw in the center of it either Phillips or t-20 torx. slightly pull up and back with it. then you will have to remove the panel where your fuse box is. not the fuse cover but the whole thing. same on passenger side. then Phillips screws on the sides of the upper dash panel. open the glove box and remove the screws there as well. it seems like there was one or two around the passenger side air bag as well just look before pulling to hard. make sure you disconnect the battery first because you will expose the passenger air bag when you remove the top dash panel. once removed the cluster will be right there with the electrical connector.
plug the new one in and reassemble. no programming is needed on that model just plug and go.
You have to replace the entire instrument cluster
Yes, 2003-2005 models are the same.
No, you cannot replace a faulty Ford Sport Trac cluster with a cluster from the 2005 Explorer.
To replace the instrument cluster fuse in a 2005 Chrysler Pacifica, first, locate the fuse panel, which is typically found under the dashboard on the driver's side. Use the fuse diagram on the cover to identify the specific fuse for the instrument cluster. Carefully pull out the faulty fuse using a fuse puller or pliers, and then replace it with a new fuse of the same amperage. Finally, ensure that the new fuse is securely in place and test the instrument cluster to confirm it’s functioning properly.
Need to know what your question is.
To replace the fuel gauge on a 2005 Kia Sorento, you'll first need to disconnect the negative battery terminal for safety. Then, remove the instrument cluster by unscrewing the screws and gently pulling it out. Disconnect the wiring harness from the back of the cluster, and replace the fuel gauge with a new one. Reassemble everything by reconnecting the wiring, securing the cluster back in place, and reconnecting the battery.
That's probably for the instrument cluster.
The instrument cluster is also the body computer.
To access the dash lights in a 2005 Kia Amanti, you will need to remove the instrument cluster. Start by disconnecting the negative battery terminal for safety. Then, remove the dashboard trim around the instrument cluster, which may involve unscrewing screws and gently prying off clips. Once the trim is off, you can unscrew the instrument cluster and pull it out to access the bulbs.
yes one just might not look as good though so i wouldnt
there non replaceable you have to get a new cluster.
A small light bulb in the rear of the instrument panel has gone out. Easy to replace, but hard to get to. The dash trim will have to be removed. Then the cluster itself. Replace the burnt bulb. Installation is the reverse of removal.