answersLogoWhite

0

In order to replace the outer tie rod end on 1994 Buick, you should start by loosening the jam nut, then unscrew the tie rod end and then remove the cotter pin. Fit it the new tie rod end and screw back all the parts.Ê

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

Where can you find the thermostat on a 1994 Buick LeSabre?

Should be at the end of the upper radiator hose.


How do you replace inner tie end rod 1995 buick?

TRY GOING TO THIS LINKhttp://www.ifitjams.com/tie_rod.htm it gives video instructions


How do you repair outer tierod end?

Remove old one and replace. Several specialty tools are required. The last step is a front end allignment.


What is the cost to replace a tie rod end in Isuzu rodeo?

The estimated cost to replace one inner tie rod end on a 2003 Isuzu Rodeo is between $121 and $227 including parts and labor. The estimated cost to replace one outer tie rod end is $118 to $205.


When did Buick City end?

Buick City ended in 1999.


When did Buick Open end?

Buick Open ended in 2009.


How much does it cost to replace a 2005 galont a tie rod?

Inner tie rod end 185.00 with labor outer tie rod end 165.00 with labor plus alignment


How do you replace a lower level ride on a 1994 Cadillac fleetwood brougham?

change over to air shocks on rear end


How do you change spark plug wires on a 97 Buick LeSabre?

To change the spark plug wires on a 97 Buick LeSabre, first pull the wires loose from the plugs. After these are removed, pull the wires loose from the opposite end and replace them.


How do you replace the thermostat located on a 1994 Chevy Impala?

The thermostat is located in the thermostat housing at the engine end of the top radiator hose.


What would cause your rear end to fish tail when you hit a bump on a 2001 buick lesabre?

I had that problem, not really a fishtail but the rear end seem to be really loose. The problem went away after replace the rear struts.


How do you replace the thermostat located on a 1985 Buick Electra?

It is at the engine end of the upper rad hose. Remove the housing and there it is. When replacing it make sure the spring goes toward the engine/