note: you will have to jack or lift the engine out of the car a few inches to accomplish this.
I have my own aurora, and have been trying to do this myself. First, you will need to remove the belt. Then, you will need to locate the pump and get the pulley off. The Power Steering pump is located on the passenger side of the engine, near the top. The cap says "Power Steering Fluid" on it. The pulley for the pump is right below that, and is one of the larger pulleys... it's in plain sight. You'll need a pulley removal tool, because the aurora power steering pulley doesn't have holes for bolt-removal. You can remove the pulley without first lifting the engine, but it can be tricky, especially depending on the tool you use. Once the pulley is removed, there are two bolts on the far side of the pump, and towards the bottom. If you haven't lifted the engine yet, here is where you will need to. Both of those bolts act like hinge pins, and must be completely removed; however, you will only be able to remove one if you haven't lifted the engine. The mounting brackets will prevent further removal. They also make belt removal/replacement a severe pain at best. If you have the engine lifted, just make sure your main line and return hose are both disconnected, pull those bolts, and it will come right out.
fdgf
Search Wiki for 1998 Chevy Suburban power steering pump replacement, the author based his answer on a 1997. Enjoy
How to replace a power steering pump on a 97' GMC sierra 1500
where are the fuel injectors in a 1997 oldsmobile aurora
remove and replace water pump in 1997 Oldsmobile aurora
around 111.75
No power steering was not in 1997 corsa. it came after 1999
To fix a power steering leak in a 1997 Jaguar, start by identifying the source of the leak, which could be from hoses, the pump, or the steering rack. Inspect and replace any damaged hoses or fittings, and ensure all connections are tight. If the pump or rack is leaking, you may need to replace the affected component. After repairs, refill the power steering fluid and bleed the system to remove any air.
The power steering is not adjustable.
how to remove a power steering pulley on a 1997 Nissan altima
To replace the power steering pump on a 1997 Nissan Maxima, first, disconnect the negative battery terminal and remove the serpentine belt. Next, drain the power steering fluid and then unbolt the pump from its bracket. Disconnect the fluid lines and electrical connectors, then install the new pump by reversing the removal steps, ensuring all connections are secure. Finally, refill the power steering fluid, bleed the system, and reconnect the battery.
If you are lucky tie rod (inner or outer) has to be replaced. If you are not lucky you will have to replace all steering mechanism (steering rack).