answersLogoWhite

0

wow this is a tough one. you have to be careful and remember take your time. i had to change one in a 84 Mercury Grand Marquis - my car had a metal frame enclosing it . 1. remove the door panel 2. remove the trim piece that looks like a windshield wiper blade, it touches the window 3 remove the large door glass 4. there may be a screw on the door frame holding the little window in place remove it now remove the screw holding it to the inside of the door panel if you see a rivet instead drill it out. 5. drop the small window frame in the door and pull it out through the large window opening. your car may have a window gasket also holding in place pull this off. this is a very difficult job so take your time .

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you replace the rear vent window on a 2001 Chevy Blazer LS 4x4 2 door?

You can replace the rear vent window on a 2001 Chevy Blazer LS 4x4, 2 door with Direct Fit Power Window Regulators.


How do you stick the door windows of a 1966 Chevrolet truck to the track?

You need to remove the vent window assembly to remove and replace the door glass


How do you replace a quarter window 1995 Dodge caravan?

Do you mean the rear vent window?The sliding door,body side and quarter glass vent windows are done using same procedure.1.Remove upper trim moulding from around the glass. 2.Remove the screws holding llatch to glass.3. Separate glass from latch. 4. Remove nut covers and nuts holding glass hinge to window opening flange. 5. Separate glass from vehicle.


How do you replace a vent glass on a 2001 jetta?

Take it to a repair shop!


Will a 1968 camaro door fit a 1967 camaro if so what will have to be done?

The hinges are different on the 67 & 68 doors. 67 also has a vent glass, 68 does not have a vent glass. You can make it work, but it wll be a tuff job. Be better off to use the correct year door.


How do you remove rear vent glass from Toyota sienns 2005?

To remove the rear vent glass from a 2005 Toyota Sienna, first, you need to remove the interior trim panel surrounding the vent. Carefully pry off the trim using a flathead screwdriver or a trim removal tool. Once the trim is off, locate and remove the screws or clips holding the vent glass in place. Finally, carefully push the glass out from the inside, ensuring to wear safety gloves to avoid injury from any sharp edges.


How do you replace door glass vw beetle?

Its not as hard as it sounds, but you have to take off the door panel first. Then you loosen the bolts for the window regulator. Then its just working the winow and out. On my 73 super beetle, I fond it easier to remove the small vent window also.


How do you close rear vent window on town and country?

drivers door has a switch for each window


How do you do adjustment on door windows on 1967 mustang fastback?

i need to know how to do the adjustment on front windows of 1967 fast back mustang There are four points of adjustement for the door glass. Two are for the vent window, these two are used to adjust the vent window in or out and forward and back. There are two more for the door glass, these two adjust level and in or out. ::AverageJoeResto.com::


How do you replace heater door control blazer?

The heater door control on a Blazer can be replaced by purchasing a new one. The heater vent will pop out with a little nudge from a flat tipped screw driver. Then insert the new heater vent door control.


How do you get out of the Bistro with the boss's glass on Spy island?

Climb up the inside of the kitchen vent, then across the light fixtures to the door.


How do you replace the PCV valve on a 1998 Mercury Mountaineer?

THERE ISNT ONE THERE IS A PCV VENT LOCATED AT THE REAR OF THE ENGINE