Turn key to the on position for 10 minutes until the security light stops flashing and turns off. Then take the key out and restart it. Its in your manual.
You can reset the 2002 Chevrolet blazer security system by removing the security system fuse. Keep the fuse out for 10 seconds and replace it to its original slot.
To reset the security system on a 2002 Jeep Grand Cherokee, insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in this position for about 10 minutes until the security light on the dashboard turns off. Turn the key back to the "Off" position, then start the engine. If the system still doesn't reset, you may need to consult the owner's manual or a professional mechanic for further assistance.
maybe
I am a gm service manager and there have been no security system recalls on 02 grand ams i have a 2002 grand am as well and my security systems keeps acting up it will activate then i cant use car because it wont turn off then i have to get it towed in and they reset it they showed me how to but it still doesn't work for me No need for a tow you sit in your car for 10 minutes until the security light goes off then you can start your car again. Its poor parts that GM choose to use. I love my Grand Ams ( on the 5th one)
The factory alarm causing the issue would be the security light flashing above the RPM guage. If the security light is flashing and the car will not start, follow the directions listed below. To reset the factory alarm, turn the ignition switch to the "on" position NOT the start position for 15min. You will see the security light go off after 15min.
I have pontiac grand am 2002. I reset alarm by leaving key fully on for 10 minutes until " security" light stops flashing. turn off key and wait for 15 seconds. Car will restart. Easy but annoying. Good luck
There is no reset for the fuel pump on a Jeep.
Howdo i reset my radio security code ml 500 2002
To reset the security code on a 2002 Pontiac Aztek, first, disconnect the vehicle's battery for about 10 minutes to reset the system. Reconnect the battery, then turn the ignition to the "On" position without starting the engine. Wait for about 10 minutes until the security light turns off, then turn off the ignition and restart the vehicle. If you have the original key, it may also help to use it to start the engine after the reset.
No such animal as far as I know.
Driver side fuse box there is a switch you push to reset.
Dodge does not use inertia/reset switches.