To reset the security code on a 2002 Pontiac Aztek, first, disconnect the vehicle's battery for about 10 minutes to reset the system. Reconnect the battery, then turn the ignition to the "On" position without starting the engine. Wait for about 10 minutes until the security light turns off, then turn off the ignition and restart the vehicle. If you have the original key, it may also help to use it to start the engine after the reset.
fuse abs pontiac aztek 2002 located
Where is the fuel shut off on 2002 aztek
It depends on if you have the Driver information center or not the owners manual will let you know or most dealerships will do it for you no charge
Pontiac does not use inertia/reset switches.
AnswerCould someone post directions on how to change the thermostat on a 2002 Pont. Aztek? Is it any different than a 2003?It shouldn't be any different....
The Aztek holds 5 qts of oil
To reset the Body Control Module (BCM) on a 2002 Pontiac Aztek, first disconnect the negative battery cable and wait for about 10-15 minutes to allow any residual power to drain. Reconnect the battery cable, ensuring a tight connection. You may also need to use a scan tool to clear any diagnostic trouble codes and reprogram the BCM settings if necessary. Always consult the vehicle's service manual for specific procedures related to your model.
Green. The 3.4 motor does not have any aluminum parts internally, so green is standard.
I have pontiac grand am 2002. I reset alarm by leaving key fully on for 10 minutes until " security" light stops flashing. turn off key and wait for 15 seconds. Car will restart. Easy but annoying. Good luck
You can reset the 2002 Chevrolet blazer security system by removing the security system fuse. Keep the fuse out for 10 seconds and replace it to its original slot.
No, a 2002 Pontiac Grand Am does not have a fuel reset button. The best way to identify any problems is to either have a mechanic look at it or to check the fuse and relay to ensure there is a proper connection.
Might be a stuck brake light switch its located at the top of the brake pedal