0
I read on the suzuki forums that disconnecting the battery for a period of time greater than 10 seconds will do it.
However, if the source of the cause of the light hasn't been fixed prior to you doing this, it will come back on when you reconnect it, good luck mine is also on, i am coming to realise that a common cause MAY be the wiring harness under the passenger seat breaking connection because of repeated seat movements. It may be just the connector you have to squeeze together.....
It's actually a problem under both seats. Clip the zip tie that's holds the wire to the bottom of both seats, unplug the wire and plug it back up. That should take care of your problem
What else can I help you with?
How do you reset the airbag light on 2006 Suzuki Forenza?
i installed a radio w/ harness and the airbag light is on, how do i turn it off or reset it?
Is there a class-action lawsuit against GM-DAT about the airbag light that stays on in 2005 suzuki forenza?
No, but there should be. I have the same problem with my Suzuki forenza. as well as numerous other safety defects. What a horrible lemon.
How do I reset Drivers side Airbag for a Suzuki Forenza?
To reset the driver's side airbag in a Suzuki Forenza, first, ensure the ignition is turned off. Disconnect the negative battery terminal and wait for about 10 minutes to allow any residual charge to dissipate. Reconnect the battery terminal, then turn the ignition to the "On" position without starting the engine. The airbag system should self-check, and any warning lights should reset if there are no underlying issues. If the airbag light remains on, consult a professional mechanic for diagnosis.
How do you reset a 2006 suzuki Forenza check engine light?
The easiest way to reset the 2006 Suzuki check engine light is to remove the fuse. Keep the fuse out for 10 seconds, and replace it to its original slot.
In the Suzuki Forenza is the check engine light common?
With my Forenza , Sometimes when backing the check engine light will come on and stay on ,and the car runs rough as it is low on power . After Turing it on and off a few times , the check engine light will turn off and the car will run normal . What's the cause of this .
How do you replace brake light switch on suzuki forenza?
To replace the brake light switch on a Suzuki Forenza, locate it on the pedal shaft, release the wires that connect it, twist and then take out the old brake light switch and put a new switch in its place. The job can be done by any handy owner.
2004 Suzuki Forenza What causes the hold warning light to flash?
Push the button that says "HOLD" next to your shift knob.
What is the hold light on a 2007 suzuki forenza for?
it allows you to hold a particular gear thereby avoiding any unwanted gear changes
What is the light beside check engine on 1991 eagle talon tsi?
airbag light. if it turns on it means your airbag will not deploy.
How do you find check engine light code Suzuki Forenza?
There is a switch close to the steering column that turns it off.
How do you reset airbag light on suzuki sx4?
To reset the airbag light on a Suzuki SX4, you can try disconnecting the vehicle's battery for about 10 minutes, which can sometimes reset the airbag system. Alternatively, using an OBD-II scanner to read and clear any stored airbag fault codes can also reset the light. If the light persists, it may indicate a deeper issue that requires professional diagnosis and repair. Always consult the owner's manual for specific instructions related to your model.
What is the dash light that looks like a steering wheel and an explanation point on the dash of your Suzuki Forenza?
it is the control of the sensitivity of the steering - see handbook
