0
What else can I help you with?
Where is the trailer light fuse in a 2006 peterbilt 387?
I have no running lights on my 2006 Peterbilt 387 all of the lights work
How do you reset the codes on a 2001 peterbilt?
You get the software for the engine (e.g., DDEC for Detroit, Insite for Cummins, and I'm drawing a blank remembering what it is for Cat) and a diagnostic connector (such as NexIQ or Inline for Cummins), pull up the fault codes, and reset them. Now, if it's something which is going to be recurring, those codes will come back until you repair the fault (if they clear at all).
Where is the fuse panel on a 359 Peterbilt?
359 Peterbilt has breakers. Dash panel (far right has 2 columns of reset buttons. macdtrucking
What are the release dates for Ultimate Factories - 2006 Peterbilt 1-3?
Ultimate Factories - 2006 Peterbilt 1-3 was released on: USA: 28 January 2007
How do you reset all codes on 2006 ford freestyle?
Disconnect your battery cable for a bit and then reconnect.
How do you clear codes in a 2009 peterbilt?
To clear codes in a 2009 Peterbilt, you typically need to use a diagnostic scanner or code reader compatible with the vehicle's engine control module (ECM). Connect the scanner to the diagnostic port, turn on the ignition without starting the engine, and follow the scanner's prompts to clear the codes. Alternatively, you can disconnect the battery for a few minutes, but this method may also reset other systems. Always ensure to address the underlying issue before clearing the codes to avoid potential problems.
How do you delete a code on a 2006 corvette with out a code reader?
find a autozone they scan and reset codes for free
Where is the speed sensor on a 2006 peterbilt 387?
On top of the transmission output.
How do you Reset engine light on a 2006 dodge dakota?
To reset the engine light on a 2006 Dodge Dakota, you can disconnect the negative battery terminal for about 15 minutes. This will clear the engine codes and reset the light. Alternatively, you can use an OBD-II scanner to erase the trouble codes directly. However, be sure to address any underlying issues that triggered the light before resetting it.
How to reset codes on a 1993 Plymouth?
You can reset codes with a scan tool or by unhooking the battery.
Master reset codes k850i?
reset
How do you reset the computer in a 2006 Chevy Silverado?
To reset the computer in a 2006 Chevy Silverado, you can disconnect the negative battery cable for about 10-15 minutes. This will clear any stored trouble codes and reset the vehicle's computer systems. After reconnecting the cable, start the engine and allow it to idle for a few minutes to help the computer recalibrate. Always ensure you have any necessary codes or settings saved before doing this, as it may reset your radio and other settings.
