0
Chances are there is more damage than just the belt being broke. If the timing chain/belt broke while moving, depending on engine speed, some valves could have kissed the pistons and you might have internal engine damage too.
The procedure is the same if the belt had not broke first. Unless you are really mechanically adept, take it to the dealer for repair.
What else can I help you with?
How do you set timing on a 1993 f-150 5.0?
where is the spout connectoe on a 1993 f150 5.0?
How do you set timing on a 1993 ford with a timing light?
yes.
How do you set timing on 94 ford f150 5.0?
timing should be set at 10 degrees BTDC. be sure you unplug the spout connector before you adjust the timing.
How to set timing chain on 97 Ford F150 v6 4.2?
you need a especial tool
What should the timing be set at on a 1990 ford f150 v8 5.0?
I believe that is 10 degrees BTDC
How do you set the timing marks on 1993 ford escort 1.9?
May be computer controlled and not adjustable
How do you set timing on 1993 van E350?
Computer controlled and cannot be adjusted.........Boo Ford......
How to set timing on 1999 Ford Expedition?
how do you set or check the timing on a 99 ford expedition?
How do you set the timing on a 1991 Ford Ranger after the timing belt breaks?
where to set timing for a 1988 ford ranger 2.2l
How do you set the time on a 1993 Ford Escort?
The timing on the 1.9L escorts are controlled by the onboard computer and CANNOT be adjusted.
Does a 2002 Ford F150 4.6 V8 have a timing chain and if have one at what milleage need to be changed?
The Ford 4.6 litre V8 has ( 1 ) timing CHAIN to each cylinder head ( so there are 2 timing CHAINS ) I'm not a mechanic / technician but there is no set mileage to change the timing CHAINS as far as I know
How do you set the timing on a 1992 ford f150?
The timing is set by timing marks on the crankshaft pulley. Using a timing light the light will sync with the engine and show if the marks line up properly. To adjust the timing the distributor is turned slightly. There is a clam and bolt under the distributor, loosen these just a bit to be able to move the distributor.
