answersLogoWhite

0

The Honda VT1100 has hydraulic adjusters, not hydraulic lifters. No adjustment is necessary. There is an adjuster for each rocker arm, but it is hydraulic - there is no adjustment possible except by varying the oil pressure. The rocker arm in the engine is fixed, so the lash is not taken out like it is on a push rod engine with hydraulic lifters. The valves cannot be adjusted but the valve lash can be set by adding or removing shims. However, the engine has to be dissasembled for this.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How do you set valves for a 400 quadrunner suzuki eiger?

how do you set the valves & what are the adjustments for the valves on a 2007 suzuki eiger 400


How do you set the valves on a Honda 500 ATV?

what filler guage size do i use to adjust valves on a 2009 Honda 500 4 wheeler


Diagram of a 1981 Honda Civic hatch back?

i have a 1985 Honda civic and the valves need adjusting with a filler gage but i do not no what to set them on


How much could I sell my Honda 1100 American Classic Shadow for?

There is no set price that you could sell your Honda 1100 American Classic Shadow for. A car in good condition sells for more than one in poor condition.


What is the valve adjustment specs on Honda Recon?

For the 2004 Honda Recon 250 the valve specifications are the following: Intake and exhaust valves are both set to 0.13 mm (0.005 in).


How do you set Timing for 1980 Honda goldwing 1100 interstate?

The best way would be to pick up a manual. Just too many things to do.


How do you set timing chain on 1986 Honda cr125?

A CR 125 does not have a timing chain. It is a two stroke which operates with reed valves.


How do you set the clock on a 2007 Honda jazz?

To set the clock on a 2007 Honda Jazz, start by turning the ignition switch to the "On" position without starting the engine. Press and hold the "Clock" button until the display begins to blink. Use the "H" and "M" buttons to adjust the hours and minutes, respectively. Once the correct time is displayed, press the "Clock" button again to set it.


Trying to set the set valves on 350 which valve is the intake and which is the exhaust you have found tdc and set the 1 valves now what?

The intake valves line up with the intake runners on the intake manifold. The exhaust valves line up with the exhaust runners on the exhaust manifold or headers. With #1 at tdc you can set 1,2,5,7 intake and 1,3,4,8 exhaust valves. Rotate the engine one revolution to #6 tdc and set the remaining valves.


What is the stock valve clearance for a 99 cbr 1100 blackbird?

The stock valve clearance for a 1999 Honda CBR 1100XX Blackbird is typically set at 0.10 mm (0.004 inches) for the intake valves and 0.15 mm (0.006 inches) for the exhaust valves. It's important to check the service manual for specific tolerances, as these values may vary slightly based on individual engine conditions or modifications. Regularly checking and adjusting valve clearance is crucial for optimal engine performance.


When are superheater safety valves set to open?

after the main safety valves are open


How do you set the clock on a 2007 Honda Fit?

To set the clock on a 2007 Honda Fit, first turn on the ignition or accessory mode. Press and hold the "Clock" button until the display begins to blink. Use the "H" (hour) and "M" (minute) buttons to adjust the time, then press the "Clock" button again to save the settings. Make sure to set the correct AM or PM as needed.