Remove the plug from the A/C pressure sensor and short out the two connectors with a paper clip. This will turn on the compressor.
To change the air compressor on a 2003 Chevrolet Impala, start by disconnecting the negative battery terminal. Next, remove the serpentine belt by releasing the tensioner, then disconnect the electrical connector and refrigerant lines from the compressor. After that, unbolt the compressor from the mounting bracket and replace it with the new unit. Finally, reconnect everything, recharge the AC system, and test for proper operation.
Chevrolet first made a van out of the Corvair series in 1961. The Astro, which was very popular, began production in 1985. The Express is now their most popular.
The pressure in the can of coolant you are adding is usually enough to start the compressor howerver you must have the air conditionig switched on in the vehicle.
Jump the compressor relay next to the fuse panel under the hood. Pull the relay out and use a piece of wire to jump the contacts. Compressor will engage, with the engine running fill with your 134a.
sounds as if you may need a tune up bad cap and wires will contribute to not starting on rainy and damp days .hope this helps.
go ahead and start charging the ac. make sure you have the car running and the air conditioning on as cold as the car can get. once a certain amount of refrigerent has collected in the lines the compresser should start working
How do i start the space ship in poptropica astro night island
1995 cherolet astro van 4.3 get gas psi 35.has spark,fuel pump working find.no, gas going throught the spider injector.injector wires get power.what could cost that wouldn't start the engine.
you need someone to jump start it
Aurora (Oldsmobile) Apollo (Buick) Astro (Chevrolet) Alliance (Am. Motors) Allstate (Sears) Ambassador (Am. Motors) AMX (Am. Motors) Aston Martin Audi Austin Avanti (Studebaker) Acura (Honda)
No. There is not enough power in a phone to recharge and start a car.
easy first by pass it with a wire link next fix leak and recharge with r134a 800grms at suction pressure of 200kpa remove wire link and re connect on to Lp switch