answersLogoWhite

0

Flip the TV upside down and there are 2 screws you have to take out on the bottom of the stand. Don't remove the 4 screws on the back toward the bottom, They look like the screws but they're not.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you take off Nissan frontier tail ights?

there are two bolts on the inside corner, i believe they are Philips screws


What does VTOL stand for?

Vertical Take-Off and Landing


What does STOL stand for?

Short Take Off and Landing.


How do you take out a factory radio on a 2002 lancer?

pull off the knobs for heater controls, on the 2 outside ones there are 2 Philips screws that need removed..after that gently pull that plastic bezel off (it just clips in) and you will reveal 4 more Philips screws holding in the radio..take those loose and the radio slides right out


If a Sailor Moon doll has a stand can you take it off?

yes


Why does your hair stand after you take your hat off?

Your hair stands on end after you take your hat off because of static electricity in the air.


Can you take the turret in Halo 3 off the stand and back on?

yes


What does pto on a tow truck stand for?

PTO stands for Power Take Off.


How do you remove the stand on a Phillips 42pfp5532d?

To remove the stand from a Philips 42PFP5532D TV, first, ensure the TV is turned off and unplugged for safety. Place the TV face down on a soft, flat surface to avoid scratches. Locate the screws securing the stand to the back of the TV, typically found at the base. Use a Phillips screwdriver to remove these screws, then gently detach the stand from the TV.


How do you remove the ignition switch on a 1994 Geo Tracker 2WD?

There are 4 Philips screws that hold the steering column cover together.They are located underneath. Two in the front, two in the rear.Pop the cover off and you will have access to the ignition switch.On the left side, there is the electronic part of the switch that is held in with a Philips screw. To take this screw out, you will need an offset screwdriver, or one of the Philips screwdrivers with a very short handle.


How do you fix electrostatic hair?

the static electricity will wear off.. Or you can take your hand off the thing that is making your hair stand up


How do you fix a Window that fell in the door of 1998 dodge ram 1500?

Open the door-stand between the door and the van-look at the armrest there are two Philips screws underneath-unscrew those. The door handle where you open the door! Open and hold it open-there is a 7/16 bolt-unscrew that. The window crank! There is a little cover take a real thin knife and pop that off-there's a Philips screw in the middle of the window crank- unscrew that and remove the window crank. Take a flat blade putty knife between the metal door and the interior door panel-Pop them off and the door panel will come off. Pull the plastic cover off-put the window crank back on and you should see from the there what needs to be done. If you need to take the other door apart and see how it works-it's really pretty simple. Richard p