answersLogoWhite

0

There is a clip behind the handle. You remove the clip and the handle comes off, just remember they are a bear to put back on with out the handle removal tool.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Where is the oil pump located on the 1989 Cutlass Calais 2.5L?

In the oil pan


Where is the fuel filter located on a 1989 Oldsmobile Cutlass Calais?

rear tire wall under car tw mills


How do you replace the starter of a 1989 calais quad 4?

You have to remove the intake manifold and be care full of the crank sensor


How do you add coolant to a 1989 Oldsmobile cutlass calais?

I have an 89 Olds Cutlass Calais SL...and you add coolant, very slowly, to the reservoir on the passenger side of the engine compartment. A little coolant, a little water, a little more coolant, a little more water...you get the idea. mixing the antifreeze 50 / 50 to start with will cut down on the confuse...tuner1978


Where is the torque converter clutch solenoid on a 1989 Olds Cutlass Calais 3.3L V6?

the tcc solonoid is located under the side pan however I highly doubt the solonoid is the prob


Where is the fuel pump relay located on a 89 Oldsmobile Cutlass Calais?

On a 1989 Oldsmobile Cutlass Calais, the fuel pump relay is typically located in the engine compartment's relay center, which is near the battery. It may also be found mounted on or near the fuse box. For precise identification, it's best to consult the vehicle's service manual or a wiring diagram specific to that model.


Where is Crankshaft Position Sensor 1989 Oldsmobile cutlass calais 2.5?

it is located under the coils and ignition modual it is mounted under it all, it comes out with the modual, and be careful if it has been there a while you may break it,


How do you change the heater core on a 1989 olds cutlass calia?

Well i recently just replaced my 1989 Oldsmobile Cutlass Calais S 2 door Heater Core. Man is it a Job! You have to dismantle the center console including the parking brake and radio to get to the heater core. once you pull all the plastic/fake leather away its pretty easy. Well i recently just replaced my 1989 Oldsmobile Cutlass Calais S 2 door Heater Core. Man is it a Job! You have to dismantle the center console including the parking brake and radio to get to the heater core. once you pull all the plastic/fake leather away its pretty easy.


Why would a 1989 Olds Cutlass Calais sometimes die while idling and get gas surges when going slow?

i had this same problem with my 85 and about 3 months later my fuel pump went out changed it, workds fine now


How do you get a window to work on a 1989 Ford Bronco?

Turning the window crank in a counter clockwise direction, the window will go down, reverse direction to raise it. If you are speaking of the rear window the switch is on the a/c control panel. Down makes the window go down and up is up


How do you replace an ignition switch for a 1989 Oldsmobile Cutlass Calais?

To replace the ignition switch on a 1989 Oldsmobile Cutlass Calais, first disconnect the negative battery cable to avoid electrical issues. Remove the steering column cover by unscrewing the screws, then locate the ignition switch attached to the steering column. Disconnect the wiring harness from the old switch and remove it by unscrewing the mounting screws. Install the new ignition switch by reversing the steps, ensuring everything is securely reconnected before reassembling the steering column cover and reconnecting the battery.


How do you change the heater core on a 1989 Oldsmobile Cutlass Ciera?

How do you change the heater core on a 1989 Oldsmobile Cutlass Ciera? or where can I get the Info on replaceing it