0
run a hot wire that becomes and stays hot when key is turned on. most chevy's had a oil pressure switch that had three prongs on it when engine was started and the oil pressure closed the switch then it put power to the choke. you can come off the fuse block with a wire because there are extra terminals there that are hot with the key on
What else can I help you with?
Switching manual carb to electric?
That is Not a good idea as you will need a computor,wiring harness,distributor and new carburator. The cost does Not justify it. yes you can put an electric choke carb on your engine with no problem, Edelbrock sells them and all you need is a hot wire from the ignition run to the carb and a ground wire, very simple operation.
Inventor of electric wire?
who invented electric wire
How do you wire a citroen saxo ignition barrel?
To wire an ignition barrel in the Citroen Saxo, begin by disconnecting the wire at the negative terminal of the battery. A lead wire has to go to the ACC terminal on the ignition barrel. The starter relay wire goes to the ST terminal and the ignition wire is connected to the IGN terminal.
What is the recommended wire size for an electric range?
The recommended wire size for an electric range is typically 8-gauge wire.
What is the third green wire on an electric drill is the wire?
it is the earth wire
What is the relationship between electric potential and a wire in an electrical circuit?
The electric potential in a wire in an electrical circuit is the amount of electric potential energy per unit charge. As the wire carries current, the electric potential decreases along the wire due to the resistance of the wire. This relationship is described by Ohm's Law, which states that the electric potential difference across a wire is directly proportional to the current flowing through it and inversely proportional to the resistance of the wire.
What is the recommended wire size for an electric dryer installation?
The recommended wire size for an electric dryer installation is typically 10-gauge wire.
What is the recommended wire size for an electric range installation?
The recommended wire size for an electric range installation is typically 8-gauge wire.
How does the presence of a charged wire affect the electric field in its surrounding environment?
The presence of a charged wire creates an electric field in its surrounding environment. The electric field is stronger closer to the wire and weaker farther away. The direction of the electric field lines depends on the charge of the wire.
What constitutes an electric current in a wire?
An electric current in a wire is the flow of electric charge, typically carried by electrons, through the wire. This flow of charge is driven by a voltage difference, or potential difference, between two points in the wire.
How can one determine the electric field in a wire?
To determine the electric field in a wire, one can use the formula E V/d, where E is the electric field strength, V is the voltage across the wire, and d is the distance along the wire. This formula helps calculate the force experienced by a charge in the wire due to the electric field.
Why does a wire carrying electric current become hot?
A wire carrying electric current becomes hot due to the resistance in the wire. As the electric current flows through the wire, the resistance causes some of the electrical energy to be converted into heat energy, which raises the temperature of the wire.
