Remove the heater-A/C housing from the vehicle. Refer to Housing Assembly HVAC/ Service and Repair/ Procedures. Remove the screws and retainers that secure the heater core to the heater-A/C housing. Lift the heater core straight up and out of the heater-A/C housing. INSTALLATION Lower the heater core into the heater-A/C housing. Position the retainers over the heater core tubes. Install and tighten the screws that secure the heater core and retainers to the heater-A/C housing. Tighten the screws to 2.2 Nm (20 in. lbs.) . Reinstall the heater-A/C housing in the vehicle Refer to Housing Assembly HVAC/ Service and Repair/ Procedures.
The heater housing is behind the dash on the passenger side.
With a scan tool.
AnswerYes if you have the moter mounts from the 2001 moter.
12 quarts
Dodge does not use inertia/reset switches.
Green
5-15 psi
No.
The idle on a 2001 24 valve is computer controlled and is not adjustable.
No, the common rail fuel system started on the 2003 model year Dodge.
In the middle of the heater box under the dash.
The lug pattern is the same but the 2003 has a larger disk brake needing a 17" rim so a 16" rim off a 2001 will not fit. However you could put the 03 rims on the 01.