answersLogoWhite

0

depend on to existence of test equepment.

if we have a single phase injection current and we want test the thermal overload we have to do serie the heater and inject current two time of thier setting.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How can I test a dryer motor to ensure it is functioning properly?

To test a dryer motor, you can use a multimeter to check for continuity in the motor windings. You can also visually inspect the motor for any signs of damage or wear. Additionally, you can test the motor's start switch and thermal fuse for proper functioning.


What sort of protection scheme do you suggest for the protection of a 10 HP motor?

1)Instantaneous overcurrent protection. 2.Ground fault protection. 3.Thermal overload protection. 4.Stalling Protection. 5.Phase unbalance protection.


How do you test motor thermal protection relay?

The thermistor motor protection relays CM-MSE, CM-MSS and CM-MSN are used to control motors equipped with PTC temperature sensors. The PTC temperature sensors are incorporated in the motor windings to measure the motor heating. This enables direct control and evaluation of various operating conditions. Depending on the products also ATEX approvals for use in hazardous areas are available.


What is the conclusion of overheat protection of induction motor?

If the overload protection is set correctly to the motors full load amperage, any overloading of the motor will trip the protection and take the motor off line. Once the reason of the overload has been established and rectified, the overload protection is reset and the motor can be brought back on line.


What device is used on a power tool's universal motor to provide a burnout-proof motor?

A thermal overload protection device is typically used on a power tool's universal motor to prevent overheating and avoid burnout. This device monitors the motor's temperature and shuts off power if it reaches a critical level, preventing damage and ensuring safe operation.


Kia Spectra blower motor shuts off?

Sounds like its getting hot and the thermal protection is shutting it down. Try cleaning it or oiling it.


How is thermal overload protection done in stator windings of motor?

one way is to use RTD sensor put inside the motor windings. The RTD sensor is connected to an electronic thermal overload relay. This type of relay can provide running temperature of the motor, on the electronic thermal over load relay display panel. RTD sensor is a wire wound resistor that changes resistance depending on the temperature


Why is thermostat turning on but motor on outside is very hot and not turning blades?

== == Most likely, the condenser fan motor is going bad. Most motors of this type have a thermal protection relay that will cut the power if the motor gets too hot.


What is the difference between a thermal motor protector and current-type motor protector?

thermal motor protector is temperature; current type is current.


Why you need over voltage protection in dc motor?

Provide thermal stability by keeping winding I2 R losses within design limits and also extend brush life


What is a motor p-lead?

Thermal Overloads


Has a thermal protection system ever failed?

yes