0
Unplug dryer! Yes the electrical cord. On front panel, remove two small screws located at bottom. Swing out front panel and about 45 degrees move panel away front dryer. The heat element coil assembly is at the bottom right side of dryer. Disconnect the two main wires from the heat element. Remove four small screws holding the heat element assembly. Two screws are located in the front cover of the heat element assembly , one is in the far end of the assembly and one is inside the assembly. The heat element assembly can now be remove from the dryer.
What else can I help you with?
How do you install the drum belt on de410 maytag?
belt diagram
What is the capacity of Maytag Dryer model DE410 serial 283538 LG?
~19.5" deep, ~80.25" circumference so about 5.8 cubic feet ~19.5" deep, ~80.25" circumference so about 5.8 cubic feet
Maytag model DE410 no heat?
We have the same dryer and sometimes if you push the button that changes the heat from regular to delicate and back again it starts to heat up again. If that's not it then I would contact a professional.
How do I install front door for a Maytag DE410 model Dryerwhich has fastening clips to hold it in place?
Place the top of the front panel tight against the top of the dryer with the clips centered over their openings. Swing the bottom of the front panel outward at an angle and the clips will pop into place with upward pressure on the panel. If you are unable to swing out at a sufficent angle, use a flat blade screw driver to gently push the clips inward and they will pop up into place. This operation can be a little awkward, but with patience can be achieved.
