dampen a rag with lighter fluid or mineral spirits. no you wont remove the polyurethane, its dry. but it will however remove the glue with no problem or blemishes in your poly.
YES! In essence wood glue is a denser version of paper glue.....
It is possible, but it's not the best practice. If you can easily remove the existing vinyl, then do so. If the vinyl won't peel up, then you should consider two possibilities: Remove the vinyl along with the wood underlayment (or scrape it off if your subfloor is concrete), or install new wood underlayment on top of the existing vinyl.A third possibility is this: If the existing vinyl is securely glued to the floor, you could apply an embossing leveler (cement-based product) in a very thin skim coat over the vinyl. This seals in any stains, levels the floor, and gives the new vinyl a nice, smooth surface to lay over (or a good surface for vinyl glue to adhere to).Most flooring manufacturers will not honor the warranty on their vinyl if it is installed over existing vinyl, unless you do the embossing leveler step above.
Soften it with Goof Off, then scrape it with a wood spatula.
To effectively remove super glue from a wood floor, you can try using acetone or nail polish remover. Apply the acetone to a cloth and gently rub the affected area until the glue softens and can be peeled off. Be sure to test a small, inconspicuous area first to ensure it doesn't damage the wood finish.
One type of glue that can be used when working with vinyl fabric is wood glue. Normal fabric glues are not necessarily strong enough to hold vinyl together, so wood glue is a better alternative.
To effectively remove glue from a wood floor, you can try using a mixture of warm water and vinegar, or a commercial adhesive remover. Apply the solution to the affected area and let it sit for a few minutes before gently scraping the glue off with a putty knife or scraper. Be sure to test the solution on a small, inconspicuous area of the floor first to ensure it does not damage the wood.
To effectively remove carpet glue from a wood floor, you can use a heat gun or a commercial adhesive remover. Start by heating the glue with the heat gun to soften it, then scrape it off with a putty knife. Alternatively, apply the adhesive remover according to the product instructions and use a scraper to remove the softened glue. Be sure to ventilate the area and wear protective gear when using these methods.
Yes, it must be a glue down wood or a floating wood floor.
if it is glued with a lino paste glue,you shouldn't have a problem with the uplift. If its glued with an acrylic glue you can rent a power stripper to make the uplift easier.
To effectively remove dried wood glue from wood, you can use a scraper or sandpaper to gently scrape or sand the glue off the surface. You can also try using a heat gun to soften the glue before scraping it off. Be careful not to damage the wood while removing the glue.
they are new vinyl strips with wood textured surface and adhesive backing for easy installation. please advice if it is applicable to the mosaic floors and will not bubble up due to moist underneath when the room temperature is low.
To effectively repair a wood floor patch, you will need to clean the area, remove any damaged wood, cut a replacement piece to fit, apply wood glue, and secure the new piece in place with nails or screws. Sand and finish the patch to match the rest of the floor.