0
Could be a bad ignitor, those were notorious for overheating and cracking in years up to 1994. The ignitor is the trigger circuit inside the distributor, by the way.
I replaced distributor and problem was fixed
I had the same problem on a 1991 626. It also was a bad igniter that I believe is built into the distributor. The mechanic said to replace the dstributor, I did, and it's still running fine. (4years later)
Bill Smith
What else can I help you with?
What sizes injectors Mazda rx-7 non turbo have?
460cc
1991 MIATA no injector pulse what to do?
92 mazda miata not pulsation in the injectors
Where are the fuel injectors located on a Mazda 6?
In intake manifold under fuel rails.
Where are the fuel injectors on 1988 Mazda rx7?
there's four injectors you have two primary and two secondary , the primary injectors are on the top of engine very visible but the secondary you would have to remove upper intake plenum to get to them ...
Why is there gas on the spark plugs causing the car not to start on a 98 Mazda 626?
No spark? Leaking injectors?
How to remove and replace Mazda b3000 fuel injectors?
how do u replace fuel injector on 2001 b3000
How do you replace fuel injectors 1990 Mazda mx6?
Take out the old ones and replace them with new ones.
What would cause my Mazda 6 6 cylinder to hesitate on acceleration?
Dirty fuel injectors or spark plugs
How do you repair fuel injectors on a 2002 Mazda Protege?
To repair fuel injectors on a 2002 Mazda Protege, first ensure safety by disconnecting the battery and relieving the fuel system pressure. Remove the intake manifold or fuel rail to access the injectors, then carefully disconnect the electrical connectors and fuel lines. Replace faulty injectors with new ones, making sure to use new O-rings for a proper seal. Reassemble all components, reconnect the battery, and run the engine to check for leaks and proper operation.
How do you install fuel injectors for 1992 Mazda miata?
To install fuel injectors on a 1992 Mazda Miata, start by disconnecting the negative battery terminal and relieving the fuel pressure by removing the fuel pump fuse and running the engine until it stalls. Next, remove the intake manifold and disconnect the fuel rail from the injectors. Carefully pull out the old injectors from the fuel rail and replace them with new ones, ensuring O-rings are lubricated. Finally, reassemble everything, reconnect the battery, and check for leaks before starting the engine.
How fast is a Mazda Mx 5?
According to reports, the Mazda Mx5 can hit 60 mph in just over 7 seconds.
What is the fuel tank capacity of a 2010 Mazda 6?
I believe its 70L, the last time I checked
