Remove the tire and wheel. Remove the and to the axle. Remove the wheel bearing seal, with a seal puller. Remove the wheel bearing. Reverse the process to install the new wheel bearing.
No, it does not have ABS front or rear.
See http://www.ehow.com/how_4506404_replace-rotor-acura-integra.html
Yes you just need to change the headlights and bumper lights along with the bumper
Try behind the grill but in front of the rad
front wheel drive
The front bumper on a 1991 Acura Integra is held on by several mounting screws. Remove all the screws and gently pull the bumper off the remaining mounting clips.
No, a 2001 Acura Integra front bumper would not fit a 1996 model. While both vehicles belong to the same generation of the Acura Integra, there were design changes and differences in the mounting points between the two model years. It's best to use a bumper specifically designed for the 1996 Integra for proper fitment and alignment.
Will acura integra gsr front spindles fit on 95 Honda civic
behind front passenger tire
The water pump on a 94 Acura Integra is located on the front of the engine. It uses the power of the engine to circulate hot water from the engine to the radiator to cool it.
On my 1990 integra, there are like 5-8 bolts underneath and 1 or 2 on the inside of each wheelwell
front right part of the under the hood