The AERA Technical Committee offers the following information regarding a cylinder head gasket leak on 1988-95 1.6L Honda Civic engines. This information does not apply to the VTEC engines. Customers may comment that oil is leaking externally or complain of a coolant loss. The information in this bulletin also supersedes Honda service bulletin 97-047, dated September 29, 1997. The current corrective action prescribed by Honda involves installing a new style (MLS) cylinder head gasket and the new head bolts Part #90005-PM3-004 (10 required). It is important to note that the torque procedure listed below should only be used for the new revised style head gasket Part # 12251-P01-004. Use the following procedure listed below to install the revised MLS gasket for 1988-95 1.6L Non-VTEC engines. 1. Carefully remove all gasket material from the head and the block with gasket solvent and an adequate scraper. The head and block mating surfaces must be clean, flat, and smooth for the new head gasket to seal properly. NOTE: Do not use power tools or abrasives to remove the gasket material, as they will damage the head and block surfaces, causing the new head gasket to leak. 2. Before the gasket solvent dries, rinse any pieces of the gasket from the coolant passages in the head and block with water. You must remove all of the gasket material to prevent engine overheating. 3. Position a new head gasket on the block and install the cylinder head. Do not use any gasket sealers (Honda gasket) on the gasket or mating surfaces. 4. Apply engine oil to the threads and washers of the new cylinder bolts. Install the bolts, and torque them in the sequence and steps shown. Do not use the head bolt tightening steps in the service manuals. Step 1. Tighten all 10 bolts in sequence to 14 ft/lbs (20 Nm). Step 2. Tighten all 10 bolts in sequence to 36 ft/lbs (49 Nm). Step 3. Tighten all 10 bolts in sequence to 49 ft/lbs (67 Nm). Step 4. Tighten bolts 1 and 2 to 49 ft/lbs (67 Nm) again. The AERA Technical Committee
No it is not.
Is the crank pully bolt on a 1993 civic 1.6 litre left or right handed thread???
No, only an Honda Civic engine will bolt up without major modifications.
What size bolt for a 2005 Honda civic DX power steering tank bracket..
134 ft/lbs per Honda Shop Manual...put light oil on the threads to aid in seating the nut...
what are the cylinder head bolt torque setting for Honda Ballade 150i
cylender head bolt torque for 1993 Mitsubishi expo
4x100
They Are 5x114.3
4x100
4x120
5x114.3