answersLogoWhite

0

For the rocker arm assy

F 2 4 6 8 12 10

r x x x x x x

o

n

t x x x x x x

1 3 5 7 11 9

Bearing cap bolts bolts torque is 12 foot lbs.

Cylinder head A

8 2 4 6 x

f x x x x

r

o

n x x x x

t 5 3 1 7

On the opposite side just reverse top and bottom.

For torque you need to use new bolts and put a light coating of oil on them as you insert them.

Then torque them to 33 foot pounds on the first step.

Then turn an additional 90 degrees

Then and I am not repeating, turn another 90 degrees

Then torque bolt A to 27 lbs.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What are the torque specks for the rocker arms on a 95 s10 2.2?

The torque specs for a 1995 s-10 rocker arm nut is 22 ft lbs.


How do you adjust rocker arms on 1995 3.4l?

They are non adjustable, just torque them to spec


What are the torque specs for the rocker arm studs for a 1995 cavalier?

22 ft-lbs


What are the head torque specs and torque sequence on a 1995 Honda Civic?

what is the engine code??


What is the torque spec for a 1995 Cadillac 4.9 liter rocker arms?

torque specs on the bolts that hold the rockers on a 4.9 cadillac motor


What are the rocker arm torque specs for a 1995 Chevy S10 2.2L?

19 - 21 ft/lbs


What are the torque specs for the rocker arm on a 1995 S10 Chevy Pickup?

well, the 1994 is 25ft. lb's


What are the rod and main bearing torque specs for a 1995 Toyota 4Runner 3.0 v6?

The 1995 Toyota 3.0 liter engine main bearing torque specification is 160 pounds. The rod bearings torque specification is 120 pounds.


Put a 1991 4runner motor in a 1995 4runner?

Typically, yes. Most 1990-1995 4runner's came with the same factory 3.0 V6 engine and are interchangeable.


What is the head bolt torque specifications and sequence for a 1995 geo metro 3 cylinder engine?

valve seal possition


How do you replace rocker cover gasket on 1995 Ford Laser liata?

To replace the rocker cover gasket on a 1995 Ford Laser LXi, first, ensure the engine is cool and disconnect the battery. Remove the bolts securing the rocker cover and gently lift it off, taking care not to damage any components. Clean the mating surfaces thoroughly and place the new gasket onto the rocker cover. Reinstall the rocker cover, tighten the bolts to the specified torque, and reconnect the battery.


1995 Mercury Tracer Torque specs for head bolts?

Torque sequence------------ l 93157 l l 862410 l ------------ Step 1: torque in sequence to 44 Ft/LBS Step 2: in sequence completely loosen all bolts Step : retorque all bolts in sequence to 44 Ft/LBS Step 4: in sequence turn an additional 90 degrees Step 5: in sequence turn an additional 90 degrees Recheck final torque in sequence***CAUTION*** engine uses Torque To yield head bolts (TTY) that permanently stretch during the initial installation. New head bolts must be used when cylinder head is replaced or re-installed to obtain proper torque.