I put in a new battery and I was unable to start the car; I am wondering if this is due to the fact that I disconnected the alarm some time ago. This is the first time I've taken the battery out since I disconnected the alarm.
My Toyota Yaris does not have a remote. That might explain it.
To disable the factory alarm on a 2011 Toyota Sienna, you can unlock the driver's side door using the key or the remote key fob. If the alarm is activated, it should stop once the door is unlocked. If the alarm continues to sound, you can also try starting the engine with the key, which should deactivate the alarm. If issues persist, consult the owner's manual for specific instructions or seek professional assistance.
In order to unlock channels on Vizio you would need a report. You can request a duplicate remote to be sent to you otherwise, you can contact customer support to find out if there are additional such as a pass code you could use to unlock the channels.
yu gotta program it
replace master switch for door locks
Not sure there is a way to reset. It may be a lock solenoid or a bad wire
To program a Toyota Sequoia remote, first, ensure the vehicle is in the "On" position without starting the engine. Insert the key into the ignition, turning it from "Off" to "On" eight times within 10 seconds, ending in "On." After the doors lock and unlock, press and hold the lock and unlock buttons on the remote for about 1-2 seconds. Finally, turn the ignition off to complete the programming process, and test the remote to ensure it works.
If you haven't already done this, try holding the trunk release button down for a few seconds on your remote. Toyota set it up this way so that you don't accidentally open the trunk when you mean to lock the doors. There is also a button inside the glovebox that will disable or enable that function. try pressing it and then use the remote.
You can open a locked auto if you have a another remote at home. using your cellphone and having the person with the remote to press the remote while you hold the phone near the car will open it It worked for me
I have an '04 Highlander and have this capability without any special programming. To unlock the drivers door ONLY, press the remote ONCE. To unlock ALL the doors AND the rear hatch, press the remote TWICE within 3 seconds.
One reason that your remote key will not unlock your Mazda 6 is that a fuse is blown. You may need to replace the batteries in the remote or reprogram the remote. A bad body control module is another reason the remote will not unlock the doors.
Unlock the car with the remote or the key in the door.Unlock the car with the remote or the key in the door.