If your front door lock make no noise when the lock/unlock is pressed on your keyless entry it's a very good chance the door lock actuator is not working and will need to be replaced. Est Cost $46 for the part and about $115-130 in labor.
If it's only the driver side door, it's most likely a wiring connection within the door. If NONE of the doors are opening with your fob, you'll just have to change the button battery inside of the fob.
Sounds like you need to replace the drivers door lock actuator.
By pushing the switch on the driver's side door panel that locks and unlocks the windows.
Is the remote's battery dead?
You can find keyless door locks for domestic properties at Go Keyless online. They sell remote dead bolt locks, remote door knob and remote lever handle locks. They are available to fit any decor in your home.
power door locks don't work on my 1997 Honda crv
Try this: Turn the ignition to RUN (do not start), press the unlock button on the keyless remote, ignition OFF. Repeat 2x. Turn the ignition to RUN, press the unlock button on the keyless remote twice, the power locks should cycle to indicate successful programming. Turn the ignition OFF and test remote.
This happened to both front driver & passenger side door locks on my GS300. Its the Actuator. The part is about $200(?) from Lexus and I believe that was the only place I could get it from. Now my backseat passenger side is going out :(
that is the way it was designed,it is a safety feature so ou can not lock keys in vehicle
The battery in the remote needs to be replaced.
To program a keyless remote for a 2004 Kia Amanti, first, sit in the driver's seat and close all doors. Turn the ignition to the "ON" position without starting the engine, then turn it back to "OFF." Repeat this process eight times, ending in the "ON" position. Once the locks cycle, press any button on the remote to program it. If successful, the locks will cycle again to confirm the programming.
To program a new remote for a 2004 Ford Freestar, first, sit in the driver's seat and close all doors. Insert the key into the ignition and turn it from the "Off" position to "Run" eight times within ten seconds, ending in the "Run" position. Once the locks cycle, press any button on the new remote within 20 seconds to program it. Finally, turn the ignition off to complete the process; the locks should cycle again, confirming the remote is programmed.