First remove the tire and brakes, the hub just slides over the lug bolts that hold the rim on, so take it off and replace it. Always put new brake pads when replacing a rotor.
To remove the brake rotor on a 1995 Toyota T100, first, ensure the vehicle is securely raised and supported on jack stands. Remove the wheel and tire, then detach the brake caliper by unbolting it from the bracket—suspend it using a wire to avoid straining the brake line. Next, remove the caliper bracket if necessary, and then unscrew the retaining screws or bolts holding the rotor in place. Finally, slide the rotor off the hub; if it's stuck, gently tap it with a hammer to loosen it.
Toyota rotor removalonce you remove hub assembly and bearings, inside the rotor the hub should be bolted to the rotor, six bolts. then separate hub/rotor.
Remove wheels Re-install 2 lug nuts to hold rotor in place Remove caliper mounting bolts Slide caliper off rotor Use a "C" clamp to fully retract piston into caliper body Replace inner and outer pads Reinstall caliper PUMP BRAKE PEDAL TO SET PADS AGAINST ROTOR PRIOR TO MOVING VEHICLE
To change the front disk brake on a 2003 Toyota Tacoma, first, safely lift the truck and remove the front wheel. Next, remove the caliper by unbolting it from the bracket and carefully slide it off the rotor. Replace the old brake pads with new ones, ensuring they fit properly in the caliper bracket, and then reassemble the caliper over the new pads. Finally, reattach the wheel, lower the truck, and pump the brake pedal to ensure proper engagement before driving.
There should be 2 screws on the front of the rotor, remove those and the rotor should come right off....you also have to take off the caliper bracket.
Remove the tire and wheel. Remove the brake assembly. The old rotor will slide off. You might need to tap on the rotor with a hammer to get it to slide off. Reverse the process to install the new rotor.
Remove the tire and wheel from your 1995 Chevy. Remove the brake assembly. Tap on the brake rotor with a mallet or hammer. The brake rotor will slide off.
Remove the brake caliper and hang it out of the way, then thread 2 8 mm bolts into the holes provided on the disk. Screw them in and the brake rotor will come off.
You remove the brake caliper frame and rotor is then loose.
Remove the wheel and tire assembly and the brake caliper then the brake rotor will slide right off.
The brake rotor specs for 93 Toyota corolla the outside diameter 255 mm and inside diameter is 142.2 mm.