If the brake lights on your 1993 Acura Vigor aren't working, it could be due to a blown fuse, a faulty brake light switch, or a problem with the wiring or bulbs. Start by checking the fuse related to the brake lights and replacing it if necessary. Next, inspect the brake light switch, located near the brake pedal, to ensure it’s functioning properly. If both are fine, consider checking the bulbs and wiring for any signs of damage or corrosion.
The acura vigor does not have a block heater.
HOW TO REPLACE A TIMING BELT ON A 1992 ACURA VIGOR? how do you change a timing belt on a 1992 acura vigor 2.5l how do you change a timing belt on a 1992 acura vigor 2.5l -------------------------------- See article at the Acura Vigor Club -- Related Links (below).
Where is the fuel pump locate on the 1992 acura vigor
To refill the brake fluid for a 1992 Acura, you need to remove the cap on the brake fluid reservoir. Add fluid until the dipstick measures full, or the line on the reservoir that says 'full' is touched by the brake fluid.
How do I remove the front rotors so I can replace the CV joints? .... After removing the brake pads and caliper assembly, of course.
You will need to unplug the connector on the hood switch. That is how you can override on an Acura Vigor.
Look for the same answer. where is the location of an 92 - 94 acura vigor flasher?
there was no 1989 vigor..acura
My 92 Vigor has 5 clyinders
you'll find the whole shop manual for the Acura Vigor for free at www.spoonertuner.com/manuals
It is usually caused by a bad alternator.