1.) Purchase new knock sensor& cable
2.) On top of the plenum next to the throttle and ASCD cables there will be a connector that looks exactly like the mating end of your new cable; disconnect the old cable and connect the new one. (The knock sensor is located about 8" below the plenum itself so the only way to get to it is by either removing the plenum and everything attached to it or by pulling the motor and getting at it from the rear [firewall side]). However, you can relocate the sensor on top of the motor as long as it is SOLIDLY mounted to the engine itself. No zip ties or something silly like that.
The knock sensor on 90-96 300ZXs is located between the engine block and lower intake manifold. please if you want to know where anything is at on a 300ZX visit www.ttxtz.com
The knock sensor on Nissan 300ZX non-turbo from 1990 thru 1996 is located below the lower intake manifold on the rear of the engine block. To replace the knock sensor the upper and lower intake manifolds need to be removed. It is always best to replace the knock sensor with a new one considering its major dissasembly.
that the knock sensor does
how do you change the knock sensor in a 2003 Chevy silverado 5.3
were is knock sensor on 3.1 cutlass supreme
underneath the intake plenum near the rear of the engine.
how much does it cost for labor to change a knock sensor in a 2002 toyota siennna van
diagram of a nock sensor in a 300zx 1996
The knock sensor on that vehicle is located under the intake manifold. The intake manifold must be removed to gain access to the knock sensor.
what sensor?
The knock sensor is under the intake manifold, which has to be removed. This should be left to an experienced mechanic.
need change knock sensor 2 bank 2 in 2000 lexus rx300