underneath the intake plenum near the rear of the engine.
The "1990 Nissan 300ZX" was a very popular model in it's time. The "Card ID" website noted the carrying capacity of the "300ZX" was noted to be a hefty 1500 pounds.
1985 - 1988 Nissan Maxima is the only other Nissan model with power window motors that will fit a 1986 300ZX.
It is right behind the brace that the spare tire is bolted to. It is a brass looking box that has two knobs that enable you to fine tune it.
I HAVE A 2002 NISSAN FRONTIER 4X4 3.3 L V6 I HAVE KNOW IDEA WERE THE KNOCK SENSOR IS LOCATED The knock sensor on the 3.3l model should be under your intake manifold, which means you will have to remove the upper intake manifold to access it. on 2.4l models, it is located on the side of the engine block.
For the 1990 to 1996 300zx model years:1. 300 horsepower for the twin turbo model2. 222 horsepower for the naturally aspirated model
The knock sensor is located under the Intake Manifold and there is a knock sensor 1/ knock sensor 2 on this model,the 2 is the one in the rear.
where is the oxygen knock sensor located on a 3000 v6 Jaguar engine 2002 model and how can i change it?
Disconnect the wire from the sensor, use an open ended adjustable wrench to unscrew it. take a new sensor and screw it in. on a different model (if not a standard sensor) there is a nut and bolt holding it in, use the steps above to replace it
The automobile manufacturer that produces the model 300zx car is a company that goes by the title of Nissan. They are a very popular car company and produce many models.
It is on the passenger side of the block, below the exhaust manifold and next to the oil filter. It is a covered by a bell shaped rubber boot with wires coming out of it. Steve There may also be a oil temperature sensor if you have a turbo model , It is on the oil pan....
by oil filter
http://www.300zx-twinturbo.com/cgi-bin/manual.cgi not sure if this is for a Nissan 92.