It is right behind the brace that the spare tire is bolted to. It is a brass looking box that has two knobs that enable you to fine tune it.
It is located on the center, top, rear of each cylinder head.
On a 1993 Nissan 300ZX, the most commonly referenced sensor is the coolant temperature sensor, which is located near the thermostat housing on the engine block. Other sensors, like the mass airflow sensor, are found in the intake system near the air filter. If you need information on a specific sensor, please specify which one.
i can't find the iat sensor for my 1987 nissan 300zx non turbo
at the rear intersection of the T-top bar with the rear cross bar.
Where is the ignition control module on a 1987 nissan 300zx
The MAP (Manifold Absolute Pressure) sensor on a 1990 Nissan 300ZX is typically located on the intake manifold, near the throttle body. You may find it mounted on the driver's side of the engine, attached to the intake plenum. It's a small sensor with a connector plugged into it, usually positioned for easy access when performing maintenance.
Update: The optical crankshaft sensor is located inside the distributor, which is on the top front of the engine on the drivers side.
The knock sensor on 90-96 300ZXs is located between the engine block and lower intake manifold. please if you want to know where anything is at on a 300ZX visit www.ttxtz.com
On a 1990 Nissan 300ZX, the crankshaft position sensor is located near the lower front of the engine, typically mounted on the bell housing of the transmission. It is positioned near the flywheel or flexplate, allowing it to monitor the position and speed of the crankshaft. Accessing it may require removing certain components for better visibility and reach.
On a 1985 Nissan 300ZX, the temperature sensor is typically located near the thermostat housing on the engine block. It is usually positioned on the driver's side of the engine, connected to the cooling system. This sensor monitors the engine coolant temperature and sends that information to the gauge on the dashboard. If you're having difficulty locating it, consulting a service manual can provide more detailed guidance.
it is located on the transmission itself
The bleeder valve for fuel injection for 1986 Nissan 300ZX is located at the furthest end of the fuel rail.