if the bumper protector is damaged yes, or else the cover will have no suppot
I need to replace the bumper cover on a Honda accord 98 EX 4door. is there a site where the screws and pags are?
To replace the front bumper cover on a 2000 Dodge Intrepid, start by disconnecting the battery and removing any screws or clips securing the bumper cover to the vehicle. Next, detach the fog light connectors and any other wiring attached to the bumper. Carefully pull the bumper cover away from the car, ensuring not to damage any clips. Finally, align the new bumper cover, reattach it with screws and clips, reconnect any wiring, and reconnect the battery.
To replace the bumper cover on a 1996 Ford Windstar, start by removing the screws and clips that secure the existing cover to the vehicle, typically found in the wheel wells, under the hood, and along the bottom of the bumper. Once the fasteners are removed, gently pull the old bumper cover off. Align the new bumper cover with the mounting points and secure it using the original screws and clips. Finally, double-check all fastenings to ensure the cover is securely attached.
how much will it cost to replace rear bumper cover on 2003 93 saab
The average cost for the part to replace the rear bumper cover on an Oldsmobile Intrigue varies between $88.00 and $124.00, depending on the year. The labor cost to replace the rear bumper will vary between $75.00 and $150.00 depending on the repair shop.
Very carefullyJimmy out!
The rear bumper cover is attached by 4 screws (behind the fender well covers, easily moved), and 4 screws inside the rear hatch. There are also 12 fasteners along the top and bottom of the bumper skin that can be pried out. Replacement fasteners cost about 5-10 dollars for a pack of 10. If you have a gray (non-painted) rear bumper, it only costs about $200 to replace it, and it's easily a DIY job.
The rear bumper cover is held onto the frame by 4 bolts. They have a 13 mm head, and are accessed from under the van. They thread directly into the back of the bumper cover, therefore no nuts to worry about. The rounded edges of the bumper cover slide over a pin, so when the 4 bolts are removed, the bumper cover can be pulled straight off.
Very carefuly.
To replace the rear bumper cover on a 2008 Toyota Highlander, first, ensure the vehicle is parked on a flat surface and disconnect the battery. Remove any screws or clips securing the bumper cover, typically found in the wheel wells and under the rear of the vehicle. Carefully pull the old bumper cover away from the body, disconnect any electrical connectors for lights, and then position the new bumper cover in place. Reattach any clips or screws, reconnect electrical connectors, and finally, reattach the battery.
To replace a Pontiac Grand Am bumper cover, start by taking out either the three bolts on the side of the fender or in front of the wheels. Remove the top pushpins to remove the cover. Push back the two pins for each headlight, and pull them up. Unplug the lights. Then, get the replacement bumper, and snap it into place like the previous one.
Hello, Do you want to replace entire rear bumper or bumper cover? Are you doing it yourself or having shop do it? You can buy a new bumper cover (primed, so you'd have it painted too) for about $200. You can surely pick one up by hunting junkyards or sites like upullourparts.com Mike