answersLogoWhite

0

Timing belt diagrams for a 1989 Acura Legend are available at local auto part stores. Service repair manuals also carry them.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

1989 Acura Legend Timing belt or chain?

TIMING BELT for the 2.7 liter V6 engine in a 1989 Acura Legend


Heater wiring diagram 89 Acura Legend?

A heater wiring diagram can be found inside a 1989 Acura Legend workshop manual. The manuals will also have troubleshooting procedures detailing how to solve common problems with the vehicle.


How do you install an after market stereo in a 1989 Acura Legend?

How do you install an after market stereo in a 1989 acura legend?


How much oil 1989 Acura Legend?

how many oil quarts do you put in 1989 acura legend when changing oil


How do you replace the alternator on a 1989 Acura Legend?

How do I put a alternotor belt on a 1991 Acura Legend


Is there a way to retrieve DTC's from a 1991 Acura Legend without using a scanner?

How do i pull codes for a 1989 acura legend


What kind of oil does a 1989 Acura Legend take?

The manufacturer of the 1989 Acura Legend recommends 10W-30 motor oil. A heavier motor oil can be used in extreme climates.


Where is the voltage regulator located in a 1989 Acura Legend?

Its inside the Alternator


How do you set the ignition timing on a 1989 Acura Integra?

Ignition timing is set on a 1989 Acura Integra by setting the distributor to the appropriate angle. When set at the factory recommended angle the car will turn over with no problems.


How do you replace the water pump on a 1989 Acura Legend?

To replace the water pump on a 1989 Acura Legend, first, drain the coolant and remove the drive belts, then detach the timing belt cover. Next, take off the timing belt, followed by the water pump bolts to remove the old pump. Install the new water pump with a new gasket, reassemble the timing belt and cover, and finally, refill the coolant and check for leaks. Make sure to consult the vehicle’s service manual for specific torque specifications and procedures.


How to replace clutch 1989 Acura Legend?

In order to replace a clutch on 1989 Acura Legend, you would have to remove the old one. You will do this by removing the jam nut that holds the pedal and disconnecting it from the throttle cable and replace it with a new one.Ê


Where is the radiator fan switch on a 89 Acura Legend?

The 1989 Acura Legend radiator fan switch can be found on the inside of the quarter panel. You can find the switch on the drivers side quarter panel.